INSTRUCTIONS FOR OPERATION OF A LATHE VERTICAL SLID.
THE SIZE OF THE TEE SLOTTED TABLE BED IS 125 MM X 100 M.
Designated in accordance with the Imperial Dial Graduation Standar.
THE TABLE MEASURES 125MM X 100MM.
MILLING ON YOUR MYFORD LATHE WILL BE EASIER WITH THIS TABLE BECAUSE IT HAS 3 TEE SLOTS ON IT THAT ARE 10 MM WIDE AT THE TOP AND 15 MM WIDE AT THE BOTTOM ALLOWS APPROXIMATELY 80 MM OF TABLE MOVEMENT.
L.
THE USE OF A VERTICAL SLIDE IN MILLING OPERATION. SLOTTED TABLE BED WITH TEE SLOTS MEASURES 125mm x 100mm AND IS DESIGNED IN IMPERIAL DIAL GRADUATION. The standard table size is 125mm by 100mm, and the table has three tee slots. THE TEE IS 10 MM WIDE AT THE TOP AND 15 MM WIDE AT THE BOTTOM, WHICH ALLOWS FOR MILLING ON YOUR MYFORD. LATHE APPROXIMATELY 80 MM OF TABLE MOVEMENT I want to give the slide a zero rating because it is so shoddily constructed.
The drive screw was installed at an angle to the center of the screw.
Is there no quality control?
