This powerful concrete vibrator has 850W of power, a diameter of 1-1/2 inches, a length of 5 feet, and a vibration frequency of 13,000 vibrations per minute. It is used to settle concrete and remove air bubbles from slabs and footings, as well as to mix concrete.
It’s durable and safe: Power concrete tools have thickened reinforced cast aluminum shells, bigger air vents, and high-strength ABS fan blades, which are high-pressure, durable, and corrosion-resistant, cutting down on the cost of your tool. A handheld concrete vibrator that is easy to use is one of the best construction tools you can get.
EASY TO USE: Striped concave point design for a non-slip handle. With a self-locking switch, when you work for a long time, you can keep pressing the lock switch. Reduce the amount of work you do and relieve finger fatigue. When the shaft is screwed on to the drive unit, no other tools are needed to do it.
WIDE APPLICATION: This concrete mixer can be used in a lot of different places, like construction and decoration, to mix concrete and make it thicker. It is used a lot in vibrating ground beams, prefabricated cement components, interior decoration, house construction, foundation laying, outdoor decoration, and many other things, too. It is an essential tool.
★NOTE: When you put the power on the vibrator is working, but the vibrating bar does not get the same frequency as the vibrator. Please hit the shell rod with the side of your head, or shake the rocker’s head for a while. After the vibrating bar knocks the hard stuff, it will have the same frequency as the vibrator to work well. If the machine doesn’t start after this, please let us know.
Specifications. Rated current: 2.8 A 220 V and 110 V are the two voltages that can be used to power things. It has a frequency of 50 Hz or 60 Hz. In this case, the diameter of the needle is 35 mm. It is 150 cm long. All together, there are 6.3 kg of weight. Packag. One 850W Concrete Vibrator is in the package. 1 – 1.5 m of Hos. NOTE: To connect the hose to the unit, it’s a “backwards thread. When the vibrator is installed and turned on, it needs to be knocked to the ground in order to start moving. How to. People who do maintenance and check thing. In order to do any work on the machine itself, you should pull the mains plug first. The brushes should be checked often and the warm-out brushes should be replaced in time. After replacing the brushes, check to see if the new brushes can move freely in the brush holder. Keep the motor running for 15 minutes to match the contact between the brushes and commentators. Every now and then, you should clean the dust and oil that has built up in the ventilation slots. Keep them clean. Any time something goes wrong, the power should be cut off and the tool should be checked or repaired. All the screws that hold things in place should be checked on a regular basis to make sure that they are properly tightened. Tighten them right away, because not doing so could cause someone else to get hurt. Do not let the tool be wet. Keep the work area well lit and don’t use power tools in damp or wet places.
If the product works well, you can buy a lot of different ones and not have any problems with it working.
