The original’mud hog’ sander, which is frequently imitated. Pad with a gear driven drive of 8 inche.
Stock removal that is both fast and controllable. Excellent for leveling and identifying high and low points.
Heavy-duty, oversize bearings, as well as only the highest-quality parts are used in this design.
Motors are constructed of steel and aluminum rather than plastic.
Produced in the United State.
a description of the produc.
The ND900 has the following characteristics: It is excellent for leveling and identifying high and low spots. Detroit 900 is a national call-in number. Rockford, Illinois, United States 8-Inch Bondo Hog Sande. MODEL NUMBER 90. 800 RPM, 0.26HP (182W), 0.26HP (182W. 3/16-inch Gear-Driven Sander “(5mm) orbit, 5.2 lbs, 1/4NPT, maximum pressure 90 PSI, maximum flow rate 23 CFM (14CFM AVG. 8 “pad (199mm in diameter). Height: 10.8″, Length: 5.5”, Width: 5.5. The original’mud hog’ sander, which is frequently imitated. Pad with a gear drive of 8 inches. Stock removal that is both fast and controllable. Excellent for leveling and identifying high and low points. THE REASONS WHY NATIONAL DETROIT SANDERS ARE BETTE. • Heavy-duty, oversize bearings, as well as only the highest-quality components • Motors made of steel and aluminum, not plastic!!. • Made in the United States of Americ. • There is no need for specialized tooling for service and maintenance (easily repaired with common hand tools). • Our DA sanders are capable of running a variety of pad sizes on the same tool. • We have over 65 years of experience in the industry, and our tools are designed for the serious professional. • The CE mark has been obtained. • Because of tighter manufacturing tolerances, the air consumption of our tools is significantly lower than that of many of our competitors, resulting in a more efficient utilization of your compressor. • All of the tools have been created with the user’s comfort in mind.
The Manufacturer’s Statemen.
Body filler removal, leveling, and paint removal are all tasks that require sanding.
It doesn’t start right away, and I have to turn it to get it to start like a cheap one. In the meantime, I’ll lubricate it and give it some time before dealing with the problem. I’m not going to give you a bad rating or review just yet. Despite this, I haven’t given up on it yet. It’s possible that it will loosen up as I use it. It is awmone in authority, and it has a tough appearance. When it comes to working, it is effective. The body of this tool should be made of composite material to reduce weight. The power setting side adjustment should be placed somewhere else so that the user’s finger does not accidentally hit it!!. There are a lot of tools like this!. The weight of this tool is sufficient for flat surfaces. Sideways sanding is something I do a lot of. thank you very much, al
