LONGER SERVICE LIFE THAN CERAMIC NOZZLES: The professional portable hand held feed sand blaster gun kit includes one 6mm high-quality boron carbide sandblasting nozzle, which has a service life that is 5 to 10 times longer than that of a ceramic nozzle, allowing you to work faster and more efficiently.
APPLICABLE ABRASIVES: The sandblaster gun is suitable for non-metallic abrasives with a mesh size of 60-150mesh, such as glass beads, brown corundum, garnet, and so on. Increased abrasives or river sand containing excessive impurities will cause the sandblasting nozzle or sand pipe to become blocked, which will result in a poor blasting performance.
Intended for dry blasting, this sandblasting gun is an excellent choice for removing paint, rust, graffiti, and scale from automobiles and other surfaces. It is also a good choice for glass blasting and the removal of paint, rust, graffiti, and scale from automobiles and other surfaces.
(This gun is also capable of performing wet blasting, but the blasting effect is not as effective as dry blasting..
Iron and copper are used in the construction of this sandblasting gun, which has a comfortable ergonomic design handle. The outer layer of the sand blaster gun is made of stainless steel, which allows it to last for a longer period of time. The handle has been ergonomically designed to increase user comfort while also reducing fatigue among operators, resulting in increased productivity at the workplace.
ATTENTION: It is recommended to use an air compressor with a capacity of more than 1 cubic meter and a power of 7.5 kilowatts, as well as abrasive 60-150 mesh, in order to achieve the best sandblasting results. Following the receipt of feedback from previous buyers, we inspected the center drilling of the gun to ensure that there was no problem before shipping it out. After receiving the product, please contact us within 48 hours to notify us of the problem, and we will issue a full refund without any conditions.
However, the finish on the outside is nice, and that is the only reason I am not awarding this a perfect score of one star. A tool of this nature can only be successful if all of its components are correctly assembled. In the process of removing the brass retaining cap in order to remove and inspect the Boron insert, I noticed some Teflon tape that had been sloppily wrapped around the insert to make up for the sloppy fit. This insert has an outside diameter of.7865″, while the corresponding hole in the gun has an inside diameter of.8865″, making it a full 10% larger in diameter with no explanation as to why. The second, and far more egregious, flaw is the 1/8-inch omission “The (.125″ ID) air jet I requested (the actual air jet bore size is a larger.164” ID) was not center drilled correctly, resulting in compressed air not exiting the center of the jet, which is required for proper operation. You can clearly see if you look down into the bore of the air jet that the drill bit that was used wandered to one side, causing the bore to be angled and out of alignment. As a result of this one simple flaw, media will impact on either side of the Boron insert rather than centered within the insert, resulting in unnecessary and premature wear. When you pay $70 for a product, you would expect it to function properly and to include the appropriate combination of parts. Despite the fact that I am generally dissatisfied with it, I am fortunate in that I am able to use the gun body and repair it by fabricating an aluminum sleeve that will accommodate the.1 round “Inconsistency in the fit of the Boron Inser. In regards to the poorly bored air jet, I will most likely just fabricate a completely new air jet assembly on my lathe to replace the damaged one. As soon as it starts working, I have to pack it up and send it back. There isn’t time for that right now.
