A powerful 6.5 amp motor that spins at 10,000 revolutions per minute.
For added comfort and control, a three-position side handle and a contoured body grip are included.
Spindle size ranges from 5/8 to 11 inches.
A two-year limited warranty is included.
Angle grinders come with a metal grinding wheel and a spanner wrench as standard equipment.
Description of the produc.
Angle Grinder, 4-1/2 in. (SMALL ANGLE GRINDER, 4-1/2 in. 6.5 amps at 10,000 revolutions per minute. The use of a metal gear case increases the durability. Handle with rubber grips that is longer than norma.
Amazon.co.
Because the Black & Decker G850 4-1/2-inch Angle Grinder has a metal gear case, it will last longer and be more durable than other angle grinders. The 6.5 Amp motor in this grinder spins at 10,000 RPM and is well suited for a wide range of applications. Additionally, a simple slide switch (which is simple to use even while wearing gloves), a 3-position side handle, and a contoured body grip for added comfort and control in a variety of applications are included. A spindle lock is included to make changing accessories a breeze. This angle grinder is backed by a limited 2-year warranty and includes a metal grinding wheel as well as a spanner wrench for assembly.
This angle grinder has withstood a great deal of abuse.
Please keep in mind that you should not attempt the following unless you are familiar with this power tool; otherwise, you risk injury.
Following the removal of the guard. I was able to get away with using an 8″ x 3/8″ grinding disk for this. I was able to get a good grip on the 1/2-inch bolts I was grinding. I used it to create a shower of sparks off some steel plates for 25 minutes nonstop, and the motor didn’t even get hot.
Using a 7″ by 1/8″ thick cutoff disk, I was able to run it through a solid 2″ by 3″ by 3-inch block of billet aluminum without any issues in about 30 seconds. Although not as fast as a band saw, a table saw is significantly more portable and versatile.
If you purchase disks with a 5/8″ hole, you will need to purchase or make a spacer to ensure that the disk is held securely in place. This was accomplished by boring out a washer to the proper ID. The fact that you have 5/8-11 screw on disks is not a problem, obviously. The majority of the disks I use are from Harbor Freight, making them extremely affordable.
