It is simple to us.
Made in the United States of Americ.
The No Go Bench Grinder Safety Gauge with Magnet (Item #: 55279) is a safety gauge for bench grinders. The ODIZ Patented USA Made No-Go Bench Grinder Safety gauge or Bench Grinder Safety scale will assist you in maintaining OSHA compliance with Section 1910.215 of the Occupational Safety and Health Administration. Because of its practical design and low cost, this is an absolute must-have for any manufacturing company. The use of a magnet attachment makes it simple to assign individual gauges to each worker. Directions. It is recommended that the No Go Bench Grinder Safety Gauge be used prior to starting the bench grinder and after each use to ensure that gaps are the correct OSHA regulation gap. In order to verify that the tool rest is within OSHA (Occupational Safety and Health Administration) 29CRF1910.215 (a)(4) standards, one end of the “No-Go Grinder Safety Gauge” is one-eighth of an inch in length, and the other end is one-eighth of an inch in length, and both ends are one-eighth of an inch in length. When the “No-Go Grinder Safety Gauge” is turned to the other end, it measures one-fourth of an inch, allowing it to be used to test the gap between the bench grinder’s top adjustable tongue guard and ensure that it is within OSHA (Occupational Safety and Health Administration) 29CRF1910.215 (a)(4) standards by not fitting into the current top adjustable tongue guard gap.
Bench grinders can benefit from a simple plastic No-go gauge. It’s expensive for a do-it-yourselfer, but it’s well worth it to keep employees safe. It has a small magnet on the back to keep it close at hand, and the bright yellow color is a nice touch. It is critical to keep the wheel gaps between 1/8″ and 1/4″ or less. There are worse ways to keep track of things. For professionals, there is an informative brochure with information on compliance that should be sufficient to justify the price. I’m pleased with it, but I’d be even happier if it were only $5.
