I have invested a little over 19 hours into a deck measuring 850sf that the homeowner applied Behr’s god forsaken Deck Over to. There is a section of the deck roughly 350sf that is under roof and is adhered far better than the rest. I just did a section that was 162sf in 80 minutes, which means I am stripping a deck down to beautiful new looking wood, ready for stain at a rate of 120sf per hour.
best angle grinder for diamabrush Related Question:
What grit is Diamabrush?
Do I need to sand after using the Diamabrush hardwood tool? Our tool contains 50 grit diamonds, and as such, we recommend following your typical sanding progression, depending on the hardness of the wood and your specific refinishing process.
What is a Diamabrush used for?
People have used Diamabrush for desks, chair seats, chests, tables, mantles, bookshelves, doors, and dressers (to name a few).
Does Diamabrush remove Thinset?
PRODUCT DESCRIPTION: This revolutionary tool provides the fastest, most effective removal of mastic, adhesives, thin-set and thin mil epoxies from concrete floors.
How do you remove mastic from tools?
If you want to remove mastic, wet it with a mixture of hot water and vinegar before leaving it to soften for 20-60 minutes. Then, scrape away the mastic with a chisel or an edge scraper. Alternatively, if you’d rather use a heat gun, be sure to wear heat resistant gloves as mastic is flammable.
Can I use angle grinder to sand wood?
When you need to remove or sand a lot of surface wood away, turning your angle grinder into a sander is the easiest and most cost effective way to do it.
What is the difference between a sander and a grinder?
Sanders are only used to sand, but grinders can be used for multiple things. They can cut through metal, strip metal, and polish surfaces. Be aware of what your project entails before choosing which of these to rent. Maybe you need both or one.
Can I use my grinder as a sander?
Can a grinder be used as a sander? Most grinders can be switched to a handheld sander just by changing the disc. Sanding discs are cheap and readily available, and flap discs, that use small overlapping pieces of sandpaper arranged in a ring, make sanding a large area with a grinder pretty simple.
How do you strip paint off a deck?
Leave the paint stripper on the wood for 15 to 30 minutes or until the paint lifts or bubbles. Apply more stripper as needed to keep it wet during this time, then scrub the softened paint from the wood with a stiff-bristle brush or scrape it off with a paint scraper.
What tool removes Thinset?
Scraping Thinset Electric chipping hammers with a chisel or electric hammer drills with long and wide blades are the tools of choice for scraping up thinset. If the thinset is bonded too strongly to the concrete, though, then a grinder with a diamond face is the more reliable option.
How do I get rid of black asbestos mastic?
Mastic must be removed using wet methods when it contains asbestos fibers. This can be done by dissolving the mastic with a suitable solvent, then using a HEPA-filter equipped vacuuming device to remove and pick-up the resulting slurry. Mastic cannot be ground, sanded or abraded to accomplish removal.
What is the easiest way to remove mastic?
Many types of mastic are water-soluble. Begin by carefully pouring some boiling water onto a small section of the adhesive residue. Allow the water to soak in for a few minutes and then use a flat wood chisel to scrape away the loose mastic.
Is black mastic friable?
Floor tile in this condition is friable and regulated by MDH. Note the white specks on the black mastic. These are pieces of tile that remained stuck to the mastic. Photo 8 – This photo shows that hand tools (hammer, spud bar) can easily turn non-friable floor tile into friable floor tile.
