Rotate the blade so the tooth is now at the back of the table and move the miter gauge/stick assembly to the back and see if it touches the marked tooth to the same extent. The blade does not move directly around the center so you will need to repeatedly go back to the front of the blade, readjust the screw, and then again measure the back. Slide the miter gauge to the front of the table and move the fence over to the screw head and insert a playing card between the screw head and the fence just so you can move the card as it touches both the fence and the screw head. Now move the miter gauge to the back of the table and see if you have the same feel when you insert the card.
Every now and then, it’s a good idea to check your band saw table for squareness to the blade. Here’s the quick method I like to use: take a piece of flat, square-edged scrap and cut a shallow kerf into one edge. If the cut doesn’t line up the table needs some fine-tuning with a combination or engineer’s square.
“If you put a reasonably wide blade and get it running cleanly where it belongs on the wheels, you can square the table using a straightedge to extend the blade and measuring to the miter slot. If the miter slot is square to the machined front of the table, you can just use a combination square on the table edge and visually verify that the blade and square are parallel.”You are not going to get.001” accuracy on a band saw, but you don’t really need to. Once you’ve got it as good as you can get, verify the alignment by freehand sawing with a sharp, properly set up blade a piece of hardwood stock a bit longer than the table is deep in a straight line marked parallel to the stock edge. If your saw is set up properly, the stock will be parallel of the miter slot.
The only manuals I have came with the upgrades; the “Sawdust Sessions” don’t seem to address trouble shooting with the upgrade table. “I repeated the setup process once again, using the cut-board alignment method described in the table manual for adjusting the fence. I discovered that the table is 2° out of alignment with the blade and the rest of the bandsaw. This may not sound like much, but it generates a ½” error across the 15″ width of the table, meaning that the table needs to be rotated 2°, or ½”, clockwise to make it square to the blade. A temporary fence clamped to the table at the skewed angle cuts perfectly.
how to square bandsaw table Related Question:
Which way should the teeth face on a bandsaw?
On a typical wood or metal cutting blade the hook or of point of the blade should be pointing down for a vertical blade bandsaw, or for a horizontal blade saw the hook of the teeth should be pointed such that they enter the workpiece first as the blade moves.
What causes bandsaw drift?
Drift is cause because the blade buckles under the load. You can see that by stretching a ribbon between 2 points and applying a pressure to one of the edges, it will turn sideway easily. A sharp blade and high blade speed will help a lot with that.