Start by turning the blade tension handle 180 degrees to release the spring tension on the blade. Most blade manufacturers recommend 15,000 psi to 20,000 psi for a common carbon-steel blade. So check the alignment with the blade under tension, plus some more tension to account for the additional blade tension due to the cutting forces.
how to change a dewalt bandsaw blade Related Question:
Why does my blade keep coming off my bandsaw?
Blade Tension Is Too Loose The most common reason why the blade is slipping off is that there isn’t enough tension to keep it on. Blades can slowly become loose after years of wear and tear, and eventually, you’ll need to tighten or replace them.
What size blade does a Dewalt DCS371 bandsaw take?
Band Saw Blade Guard, Size 14-1/2 in x 4-7/8 in, For Use With DCS371 20V MAX.
Can I put a wider blade on my bandsaw?
An 18-inch diameter wheel can use a 0.032-inch thick blade that is 3/4 inch wide. In general, thicker and wider blades will be the choice when sawing dense wood and woods with hard knots. Such wood needs the extra strength of a thicker, wide blade to avoid breaking. Thicker blades also deflect less when resawing.
What do you do with old bandsaw blades?
There is life for those old, broken, and dull bandsaw blades. Just cut the old blade into sections about 12″ long. Stack the pieces together, alternating the teeth so that they don’t touch their neighbors. Use either same tape, or just braze the ends together,.
How do you take the blade off a DeWalt miter saw?
To unlock the head of the saw, press the handle on the saw down and pull the pin under the handle to release the lock and move your blade up and down.
How tight should my bandsaw blade be?
The blade should deflect no more than 1/4 in. A good place to begin is to tension the blade until the meter reads proper tension for the next wider blade. For example, if you’re tensioning a 3/8-in. blade, I would set the scale to 1/2 in.
How tight should a sawmill blade be?
For carbon steel toothed blades (cutting blades) this is typically 15,000 to 25,000 PSI. Slitting type blades typically are tensioned in the range of 12,000 to 20,000 PSI. In general bandsaw blades are never tensioned past 35,000 psi.