This is another video tutorial that gives you a thorough explanation of how to construct your bandsaw fence. The tutorial also comes with a few tips and tricks for your bandsaw fence to make it better. You would need to make notes as you go through the tutorial because there are some important points he makes regarding the design within the tutorial.
To put the fence on the right side of the blade, unscrew the fence from the clamp, turn it around and remount it. Tap the bit with a hammer through the hole in the bandsaw table to mark a pilot hole on the fence rail. For wider capacity, temporarily extend the fence’s rails by remounting them in a second set of holes.
A good fence can make your band saw one of the most useful machines in your shop. This fence can be made in a weekend for around $20, and it will do a great job on your band saw. You can adapt this fence to any band saw, but the dimensions given here are for my 14″ Delta.
By: John Doyle Resawing and ripping at the band saw has one set back – drift. To correct for blade drift, the angle of the band saw fence shown here can be adjusted. Slide the fence over the rails and tighten the clamps.
Of course, one of the reasons for not using the band saw more was the inconvenience of the temporary fence and I knew that with a better fence, the band saw would see more action. The high fence clamps to the main fence using carriage bolts and wing knobs. These clamp the high fence to the upright on the main fence holding it firmly.
how to build a band saw fence Related Question:
Can you cross cut with a bandsaw?
A cross cut sled for band saw is a very useful addition to any shop and will make it a lot easier to get straight cuts on the band saw. This particular jig features a very useful clamping system which makes it easy to hold the wood in place, and make mitered cuts too.
How thick of wood can a bandsaw cut?
Band saws are the undisputed champ when it comes to cutting curves and slicing through thick material. Many small band saws can slice though lumber a full four inches thick, and bigger saws handle six-inch cuts.
How high can a bandsaw cut?
The resaw capacity is the maximum height (thickness) that can be cut. For the small shop furniture maker, go with 14″ as the minimum for a bandsaw, though 16″ is better. Those doing larger work might even want 18″ or 20″ machines. Just make sure you have a minimum resaw height of 12″ for versatility.