This is another video tutorial that gives you a thorough explanation of how to construct your bandsaw fence. The tutorial also comes with a few tips and tricks for your bandsaw fence to make it better. You would need to make notes as you go through the tutorial because there are some important points he makes regarding the design within the tutorial.
To put the fence on the right side of the blade, unscrew the fence from the clamp, turn it around and remount it. Tap the bit with a hammer through the hole in the bandsaw table to mark a pilot hole on the fence rail. For wider capacity, temporarily extend the fence’s rails by remounting them in a second set of holes.
A good fence can make your band saw one of the most useful machines in your shop. This fence can be made in a weekend for around $20, and it will do a great job on your band saw. You can adapt this fence to any band saw, but the dimensions given here are for my 14″ Delta.
2×4″ extrusion 1×2″ extrusion 1×1″ extrusion 2×2″ corner brace 4″ linear bearing to fit 1010 extrusion 1-7/8″ linear bearing to fit 1010 extrusion 1/4-20 fixturing knob + 1/4-20 carriage bolt + 1″ spacer Linear bearing brake + bolt 1/4-20 specialty nuts & bolts Shim Stock………. If you order 80/20® stock off of Ebay, you don’t necessarily get the lengths you want. Align the holes in the extrusions with the screw heads and snug down the screws. Position the extrusions and braces then firm up two screws on each brace and check for square.
how to build a bandsaw fence Related Question:
Do you need a fence for a bandsaw?
If you use your bandsaw only for making curved cuts, you’ll likely never need a rip fence. For accurate ripping and resawing, though, a good fence helps greatly. That said, many bandsaws don’t come with a fence. Those saws that do have fences, particularly on lower-cost models, often don’t work that well.
What is a resaw fence for bandsaw?
Re-sawing allows you to create wide panels from narrow boards, thin pliable pieces for bent laminations, thin sheets of veneer, and even turn logs into lumber.
How thick of wood can a bandsaw cut?
Band saws are the undisputed champ when it comes to cutting curves and slicing through thick material. Many small band saws can slice though lumber a full four inches thick, and bigger saws handle six-inch cuts.
How high can a bandsaw cut?
The resaw capacity is the maximum height (thickness) that can be cut. For the small shop furniture maker, go with 14″ as the minimum for a bandsaw, though 16″ is better. Those doing larger work might even want 18″ or 20″ machines. Just make sure you have a minimum resaw height of 12″ for versatility.
How thick of wood can a 9 band saw cut?
There are several $99, 9 inch band saws on the market in my area (Ryobi, Skill). The are able to cut a thickness of 2 ½ inches.