I first tried out the DeWalt cordless band saw on some Schedule 40 PVC pipe and some PVC electrical conduit. “To give the DeWalt cordless band saw something a bit more challenging, I clamped down a piece of ½” galvanized steel pipe, and made a couple of cuts. The DeWalt cordless band saw we got to evaluate was the bare tool version, the DeWalt DCS371B. This is a great option for anyone already invested in the DeWalt lineup, as it will work with any DeWalt 20V MAX battery.
SOLVED: How do I adjust the tracking on a dewalt portable – Fixya. Loading…. Oops :Please try again.
how to adjust blade on dewalt band saw Related Question:
Why does my bandsaw blade wander?
If the wheels are worn and do not have a distinct top to the crown then the blade will not know where to go, and may wander around. This of course can cause poor cut quality and difficulty in setting the guides.
Why does my bandsaw blade keeps coming off?
Blade Tension Is Too Loose The most common reason why the blade is slipping off is that there isn’t enough tension to keep it on. Blades can slowly become loose after years of wear and tear, and eventually, you’ll need to tighten or replace them.
How much tension should there be on a bandsaw blade?
For carbon steel toothed blades (cutting blades) this is typically 15,000 to 25,000 PSI. Slitting type blades typically are tensioned in the range of 12,000 to 20,000 PSI. In general bandsaw blades are never tensioned past 35,000 psi.
Why does my bandsaw blade wobble?
The blade on a saw left idle for long periods of time can leave an impression in the rubber tire which might cause erratic tracking. Purchase and install aftermarket replacement tires. (Search for “bandsaw tire” at woodcraft.com.) If you still see a back-and-forth motion, the culprit is probably the wheel itself.
How tight should a metal bandsaw blade be?
The blade should deflect no more than 1/4 in. A good place to begin is to tension the blade until the meter reads proper tension for the next wider blade. For example, if you’re tensioning a 3/8-in.
Why does my bandsaw bounce?
A lack of straightness in either the blade or weld could be causing the blade to bounce. Next, it is important to check the blade tension and make sure that it is high enough to keep blade bounce to a minimum. That way, your blade won?t take as much damage.