Make sure the saw is turned off, then loosen the depth adjustment knob and raise the flat metal bottom piece until one tooth of the blade extends under the piece you wish to cut. If you are trying to cut at a 90 degree angle but it keeps coming out as a more acute angle(>) turn off the machine, then try loosening the knob by the front of the saw blade. To tighten the blade, screw the washers in the center of the blade clockwise using the blade wrench.
dewalt cordless band saw not working Related Question:
Why is my bandsaw not working?
A bad power supply, broken power cord, failed on/off switch or bad drive motor can prevent the band saw from starting. Check the power supply first. Plug a shop light or other electrical tool into the electrical outlet that you’re using for the band saw to make sure the outlet works.
Why is my bandsaw blade twisting?
The difference between the steak and the bandsaw is where the steak knife is short and thick, the bandsaw blade is generally long and skinny. This becomes a problem because it is possible to push hard enough on the blade to cause it to twist left or right.
What size blade does a Dewalt DCS371 bandsaw take?
Band Saw Blade Guard, Size 14-1/2 in x 4-7/8 in, For Use With DCS371 20V MAX.
What is the purpose of a portable band saw?
The portable band saw is one of the few tools that, when used with the right blade, is equally effective regardless of material. It can cut straight lines or curves, so it can be used for joints, precision cuts, or decorative work.
What is the throat on a band saw?
The throat is the distance from the blade to the vertical frame section of the body of the saw. This distance determines the width of cut that can be completed on the band saw. The throat on a free-standing cabinet band saw typically exceeds the 12 to 14-inch throat of smaller, bench-top models.
What speed should you cut metal with on a band saw?
To cut steel, you’ll need to run the machine at a much slower speed — about a hundred feet per minute. A machine running at this speed might look like it’s running too slowly, but running it any faster almost guarantees that you’ll damage the blade.
How does a band saw operate?
When the saw is set up for a cut, the operator raises the saw, positions the material to be cut underneath the blade, and then turns on the saw. The blade slowly descends into the material, cutting it as the band blade moves. When the cut is complete, a switch is tripped and the saw automatically turns off.
What causes bandsaw drift?
Drift is cause because the blade buckles under the load. You can see that by stretching a ribbon between 2 points and applying a pressure to one of the edges, it will turn sideway easily. A sharp blade and high blade speed will help a lot with that.