It is not very difficult to replace the sandpaper belt on a belt sander. While sliding the new belt, be mindful of the direction arrows printed on the belt – position the belt in a way so that the belt moves in forward direction. Here is a video tutorial that demonstrates how to change a sander belt.
how to change belt on a belt sander Related Question:
How do you put a sanding disc on a sander?
To attach a hook and loop sanding disc to your sander, face your sander upside down and simply place the surface of the disc – which has the tiny loops – on the backing pad, and employing pressure, press both surfaces together.
How do you tighten an old Craftsman belt sander?
Older model Craftsman belt sanders do not have a tensioning lever. Push the front roller against a hard surface — such as a workbench — when relieving pressure on the belt to change it. After installing the new belt, use a screwdriver to snap the roller back into position.
What size belt does a Craftsman belt sander use?
Attach Craftsman’s 4 x 36-in. Sanding Belt, 50-Grit to your belt sander to produce a smooth and professional-looking surface on wood, metal, plastic, fiberglass and more.
How do you change the sandpaper on a Black and Decker sander?
Insert the screwdriver tip into either tensioned end clip and lift the screwdriver upward to bind the clip and spread the sandpaper opening. Slip the end of the new sandpaper piece approximately 1/4-inch into the clip and flush with each side of the sanding pad.
Why won’t my sandpaper stick to my sander?
Orbital sanding pads won’t stick if debris or tears in material are present. To replace the hook and loop / Velcro pad: Simply remove the three screws on bottom of sander to replace pad. Here is a link to a replacement pad. Apparently everyone one else is just experiencing worn out sanders or sandpaper disc’s.
Why are there holes in sanding discs?
These holes help to pull dust away from the sandpaper’s surface so it doesn’t become clogged with sanding debris. Without the holes, the dust would gunk up on the sandpaper surface which would create a layer between what you are sanding and the abrasives, causing it to not effectively work.
When should I change my sanding disc?
You should change your sandpaper when it gets too clogged by the material you are sanding or if the abrasive side is too worn down to smooth out your surface. If you have noticed that you have to apply much more pressure or it takes too long to work, you should substitute your sandpaper.
How much tension should a belt sander have?
Most wood sanding applications (such as mould sanding using narrow cloth belts) require a belt tension of approximately 40 psi. However, there are some special exceptions. For example, abrasive planing operations using coarse grits typically demand belt tension in the range of 70 to 90 psi.