More info about how to glue belt sander

“First, peel the remaining factory tape off the belt splice. Cut a piece of cloth bias tape about 2” longer than the width of the belt. Lay one end of the belt, grit-side down, on the bench; then apply cyanoacrylate glue to the end of the belt. Wrap the belt around and repeat the gluing process to reconnect the ends of the belt.

Yup Drew, Lap joint belts have arrows, so the joint does not catch on the platen. Tod & Wes, I had heard that the shelf life of belts is not at all too long. Wes, I am thinking that the tape used to join these belts looks a lot like fiberglas strapping tape.

Test your joint before putting your newly glued sander belt on your sander. Unfortunately a lot of glues will not hold when used with a belt sander due to the extreme heat and tension your belt sander is under when working and it is best to buy a new belt that is designed for your machine, but if you need a quick repair to get your machine up and running again this is an option. You need something that has great strength and durability as your belt sander is a very hard working machine and your belt is going to be exposed to a lot of heat and tension.

how to glue belt sander Related Question:

What tape is used to join sanding belts?

Apply the Scotch 8959 tape by using a small piece of swimming pool noodle or other firm foam/rubber like a squeegee pressing firmly and leaving overlap on both ends, make sure there are no air bubbles and the tape is perfectly flat covering both splice ends equally.

Why do the belts keep breaking on my belt sander?

Heat, humidity, and age can contribute to belt seam failures, but they’re not the only causes. Check that your belts are turning in the direction indicated on the inside face. When not using your sander, release the tension on the belt.

Can you cut sanding belts?

You can cut sanding strips from sanding rolls or sanding belts. Cutting from sanding rolls is the more ideal solution. The key is to trim the leading edge so that the angled edge matches the drum circumference.

How do you store sandpaper belts?

Sanding belts should be stored on a rack and sanding discs and wheels should be stored on/in racks, bins, drawers, or boxes. Improper storage can impact the safety of the abrasive, especially for sanding belts.

Leave a Reply

Your email address will not be published. Required fields are marked *