Trying to make adjustments with the motor at full rpm is tough if the belt isn’t right. I just snug up the tension screws until the belt is tight enough to roll by hand without slippage. I’ve found that if I adjust the belt in the vertical position, I can see the adjustment rollers and adjust the belt in the proper direction, rather than guessing wrong on which way to turn the wrench from the top side in the horizontal position.
Craftsman belt sander belt slips or Makita belt sander belt slips, a well-worn belt causes the same issue for belt sanders of any brand. How to Fix the Well-Worn Belt Problem:Take out the old belt and install a new one and see if your belt sander’s belt is slipping In case it’s sliding again, troubleshoot with other given solutions. The last cause for the belt sander belt keeps slipping problem is the tension lever problem of the sander.
Unplug the Black and Decker belt sander power cord from the wall outlet. Slide the old sandpaper belt off the belt sander front and rear rollers. Disconnect your black and decker sander from power source.
how to adjust tension on belt sander Related Question:
How much tension should a belt sander have?
The proper range for the tension pressure depends on whether your belt is paper, cloth, or Polyester. For paper – 45-55 psi, cloth – 55-65 psi and Polyester – 65-85 psi. Q) Is there a way to increase the life of the wide belt? A) Yes!