“The slot for a #0 biscuit measures about 21⁄8” wide, so you can’t hide a biscuit joint in stock narrower than this. Even a well-tuned biscuit joiner can sometimes cut slots that result in a non-flush-fitting joint. Cutting the spline slots on your tablesaw requires a tall jig, but you can cut them easily and quickly with your biscuit joiner and the attached fence jig, see drawing below.
Nothing is more aggravating than a biscuit that won’t fit into a slot-except maybe a whole bag of biscuits that won’t fit. Cut the slots too deep and most of the biscuit is buried in one side, weakening the joint. Cut a test slot, slip in a biscuit and draw a pencil line.
A biscuit joiner is also known as a biscuit jointer, plate joiner or plate jointer probably among other things. A biscuit joiner also gets known as a biscuit jointer, plate jointer or plate joiner. A biscuit joint is a joint created using wooden biscuits glued in to slots created by a biscuit jointer!
When adjusted properly, the biscuit joiner will cut a slot 1/32″ deeper than half the width of your biscuit. As you begin to setup for your cut, start by carefully positioning the biscuit joiner to align with your biscuit placement mark. Once you get solid placement of the biscuit joiner and fence, find the detent on your biscuit joiner’s fence, place your thumb firmly on the detent, and let go of the handle to allow the biscuit joiner to “Bottom out” on the work piece.
biscuit joiner use tips Related Question:
How many biscuits should I use to join wood?
Two biscuits per foot is a great rule of thumb, but the goal is just to make the alignment task easier. So, if you have a couple of edges that are 24″ in length and are dead straight & perhaps you would only need two biscuits to do the job.
Are biscuit joiners worth it?
Biscuits joints serve best as a quick and easy way to keep glue-up parts in alignment, and that they add appreciable pull-apart to strength joints that would be otherwise too weak to stand on their own – like butt joints and miter joints.