Unlike edge cuts, you cannot simply mark a line and snap the tile. Since you cannot see through the tile, you have to mark the exact location of the receptacle another way. Then cutting requires finesse so as not to break the tile along with a few specific tools.
There are a few simple things that need to be done if you want to cut an outlet hole in a tile. There are actually two different tools that can be used to cut an outlet hole in a tile, a tile saw and an angle grinder with a diamond cutting wheel. You will need to cut the front of the tile and on the back of the tile.
Today’s tutorial shares how to cut tile around outlets. Patience and a keen eye along with the Montolit Squadro will help make perfect cut tile around outlets. Montolit also has great manual tile cutters like the Masterpiuma, which can also cut glass tile.
Your best bet is to clamp the tile to a flat surface and drill a hole at each of the four corners using a diamond coated bit. Next, use a diamond coated saw blade in a small circular saw, grinder, or tile saw to carefully plunge cut between the holes. Remove the center section, and use tile nippers to break off any protrusions that remain.
how to cut out outlets in ceramic tile Related Question:
Is there a tool to cut holes in tile?
For cutting larger holes in tile, you can select from carbide-tipped masonry bits or diamond-tipped hole cutters. Just like the smaller bits, the cutting action of the carbide bits should be lubricated with water to reduce heat.
How do you score an already installed tile?
Turn the angle grinder so the blade will meet the tile perpendicularly. Turn on the grinder and push the blade straight down into the tile and its backing. Once you have cut through, you can pull the blade back for a short cut, or push the blade away from you to continue cutting through the tile for longer cuts.
Can you cut ceramic tile that is already installed?
Use an angle grinder to cut the tile. If you are cutting a curve, make small, straight cuts and return later with a ceramic tile file or your Dremel tool to clean up the curve.
How do you cut tile without cracking it?
Because of the compressed, fragile nature of tile, it can crack, break and fragment when you try to cut it. The best way to keep tile from cracking is to use a score-and-snap tile cutter or a diamond wet saw.
Can a Sawzall cut tile?
You can cut tile with a reciprocating saw if you’re not planning to use them afterwards (demo). A reciprocating saw with an abrasive grit blade will make short work of ceramic tile, stone, and the mortar behind them, which will significantly speed up your kitchen or bathroom demolition job.
Can you cut tile with an oscillating tool?
For some DIYers, an oscillating tool is among the best tools for cutting tile. An oscillating multitool can replace a tile nipper (since it also works by cutting the tile edges to shape it) but cannot replace a manual tile cutter or a wet tile saw and other tile cutting tools.
Will carbide cut ceramic tile?
Ceramic tile can be drilled with a carbide bit, while glass and porcelain call for a diamond-tipped bit. While that sounds expensive, a ΒΌ inch diamond tipped tip costs under $20, and a carbide bit of the same size can be had for less than $10. When in doubt, buy the diamond bit. It will drill any type of tile.