It is an air pneumatic needle slag cleaner, which is used to clean and deburr tools.
These 12 hardened 3mm steel needles can remove weld slag, paint, rust, dirt, and other things from your hands. There is a working trip of 6-7mm and 4000 blows per minut.
One-trigger operation doesn’t have to do a lot of work and is easy to use. Professional touch triggers not only make people more comfortable, but they also make it easier for them to start and stop their cars.
With its small size and high performance, this lightweight needle rust remover is designed to clean small areas without a lot of messy abrasive blasting. It’s great for getting rid of rust, dirt, paint, and weld slag from hard metal surfaces.
Needle scalers are easy to change without special tools. It also has an exhaust design that keeps the human body out of the dust, and a stainless steel filter to keep the dust from getting into the inside of the car.
Descriptio.
12 hardened steel needles on this needle scaler work at a speed of 4000 BPM to get rid of hard-to-reach rust, dirt, paint, and weld slag.
You can use this tool to clean off things like tools, equipment, and more. It’s made out of carbon steel and is great for that.
Great for welders, auto mechanics, do-it-yourselfers, and people who like to do things on their own.
A product’s feature.
Working trip: 6 to 7m.
4000 blows per minut.
Needle length: 3m.
Do you have 12 needles in your arm.
4CFM of air was used.
The air inlet connector is 1/4 “.
The weight: 1.1k.
This thing is great. This one was a little more expensive than the one from Harbor Freight, so I bought it. A good thing I did. My 10 gallon compressor runs it all the time without a hitch. The metal floor joists of a very old 1993 three-horse slant trailer were quickly descaled by a man. It rusts quickly. Down to the bare metal and very happy. This scaler is very strong and well made. There’s a sense that this is a factory. It has a solid steel construction with good needles and no leaks right out of the box. Added some oil and went to work. Do this every two or three hours while the machine is running. It works great.
