To do that, you will need to learn how to tighten the chain on electric chainsaw to retighten it to the saw bar properly. To be honest, tightening an electric chainsaw chain is a very straightforward process. A chainsaw chain is one of the main components of an electric chainsaw.
If the flats on the chain hang out of the bar groove, it needs adjusting. Holding guide bar tip up, turn tensioning screw clockwise – correct tension depends on the chain temperature. Cold Chain Tensioning: If you haven’t started cutting yet, the chain should fit snug against the underside of the guide bar.
Tightening the screw will tighten the chain, and loosening will loosen the chain. Visit our Chainsaw Chains page to our inventory of available replacement chains and other chainsaw accessories. eReplacementParts.com stocks thousands of parts for many major chainsaw brands, including Echo chainsaw parts.
The good news in this is that by following the steps in this article the chain of your electric chainsaw will be tight in less than a minute. To tighten the chain of your chainsaw, all you need is a socket wrench, or if you don’t have one, an adjustable wrench. To tighten the chain, turn the screw head with your screwdriver enough to tighten the chain to a desirable tightness.
how to tighten electric chainsaw chain Related Question:
Can you over tighten a chainsaw chain?
There is a tension screw located near the base of the bar on the chainsaw. To tighten the chain, turn it clockwise, and to loosen turn it counterclockwise. Don’t over-tighten the chain as this could cause it to break.
How do I know if my chainsaw chain is too loose?
The chainsaw chain should feel snug but still pull freely. Finally, perform a “snap” test to ensure proper saw chain tension. Simply pull the chain on the underside of the guide bar down so one or two drive links are out of the guide bar rails and release it. The chain should snap directly into position.
How often should you tighten chainsaw chain?
The chain isn’t actually becoming tighter—instead, as you turn the tensioning pin—it pushes the chainsaw bar out a little bit, which takes up the slack on the chain. During a typical afternoon wood-cutting session that lasts 2 to 4 hours, you may need to tighten the chain two or three times.
Will a chain fit a Worx chainsaw in Oregon?
Where can I find a replacement locally? If you need a fast, local alternative for the Worx 16″ Chainsaw Chain, you can use Oregon chain model 91PX057X. These can be found at most local hardware or home improvement stores.
How much tension should a chainsaw blade have?
A properly-tensioned chainsaw chain should still be just a little loose on the chainsaw guide bar, but the chain needs to be tight enough that you can’t pull the drive links out of the bar nose.
Why does chain Keep Coming off pole saw?
If your chain is tensioned too loose, it may release from the guide bar during operation, which would be dangerous. Proper chain tension should be maintained at all times. Keep in mind that as the chain warms during use, the chain will naturally loosen.