If you have problems with your chainsaw coil you can test is with using a multimeter or a multitester. To test the resistance of the coil in your chainsaw which is called a bench test, take your multimeter and remove the coil from your chainsaw to get easy access to its electrical terminals. To conclude this blog post, I would say that after reading the comprehensive and detailed step by step guide given above, you can easily perform a test of the chainsaw coil using a multimeter.
A chainsaw coil is one of the most important parts of your chainsaw. A bad or broken coil can lead to a faulty saw that doesn’t work, so it’s important for you to know how to test your chainsaw coils yourself. You have been able to complete the chainsaw coil test with the help of a multimeter.
An ignition coil gets used to transfer voltage signals to the spark plug to ignite the fuel and air mixture in the chainsaw. You can test the circuit by attaching the positive end of the coil to the multimeter and attaching it to the high output terminal traveling to the spark plug. All the steps mentioned above will help you test the chainsaw ignition with a multimeter and maintain your chainsaw over time.
If you observe a spark jumping between the tips of the spark plug gap, it means the chainsaw coil is good. If there is no spark, it means the chainsaw coil will need to be replaced. On the other hand, if the electrical coil is physically intact, it may still work well after a repair so get your tools ready to rewind the coil.
how to test chainsaw ignition coil Related Question:
How do you check a coil on a chainsaw with a multimeter?
Locate the coil on your chainsaw. Connect the negative and positive cords of the multimeter to the negative and the positive terminals of the coil in your chainsaw and measure the resistance. A brief answer is convenient for those who are short of time but it will not give you the necessary details of the matter.
What should the Ohms be on a coil?
You should have a resistance reading of at least 3-4.5 ohms. A bad coil will show a higher reading then 3-4.5. Next, place the red or black lead from the meter to the centre of the coil , and to either one of the terminals positive or negative. You want 9500-10000 Ohms, a little less is ok but no more.
Can you test a coil pack?
Fortunately, there is an easy way to test the coil packs in your vehicle and make sure they’re working as they should. You need to use ohm meter to test the coil pack for continuity. Make sure you have the approximate ohm values for the coil pack.
How do you check a coil on a Husqvarna chainsaw?
Pull the start rope on the chainsaw and watch the end of the plug as you do. If you observe a spark jumping between the tips of the spark plug gap, it means the chainsaw coil is good. If there is no spark, it means the chainsaw coil will need to be replaced.
How does a chainsaw ignition coil work?
Electrical currents run through the ignition coil and transmit electricity to the spark plug. The electricity creates sparks within the spark plug, and the sparks ignite the fuel in the engine, enabling the chain saw to run. Testing the ignition coil at home is simple to do and requires minimal tools.
What would cause no spark from coil?
Loss of spark is caused by anything that prevents coil voltage from jumping the electrode gap at the end of the spark plug. This includes worn, fouled or damaged spark plugs, bad plug wires or a cracked distributor cap.