Starting a chainsaw is not difficult, but it does require following a few simple steps in a precise order. Fill the chainsaw with the proper mixture of fuel and the correct type of oil according to Stihl recommendations for your model. Press down on the fuel bulb a few times when starting the chainsaw for the first time or when restarting after refilling a saw that has run out of fuel.
Before You Start the Chainsaw Make sure your Stihl Ms 250 chain saw is working, and maintenance is done after every use. Starting Your Stihl MS250 Chainsaw Remove the chain cover before starting the chain saw. Make use of your Stihl Ms250 chainsaw readers’ manual whenever you have a question to ask.
how to start stihl chainsaw ms250 Related Question:
Is there a trick to starting a Stihl chainsaw?
Press and hold the throttle trigger lockout (located on the side of the chainsaw, above the trigger) with your thumb, then move the master control (on the left of the rear of the chainsaw) down as far as it will go. This is the position you should start the chainsaw in the first time you use it each session.
Why will my new Stihl chainsaw not start?
If the engine doesn’t start on the first three or four pulls, the fuel and air mixture becomes fuel rich, and if you continue to pull the starter while the choke is closed, there is too much fuel to ignite and the engine floods. You can simply wait for the fuel to drain, but there is a faster way to clear the engine.
How do you start a chainsaw that won’t start?
If you believe fuel has flooded the chainsaw engine, pull the starter cord several times while holding the throttle, dry and replace the spark plug, and then try starting the chainsaw again.
Does a Stihl ms250 have a compression release?
The Stihl MS 250 C compression release will need to be replaced if it is broken or has significant carbon build-up. Carbon build-up can result from too much oil in the gasoline [mixed rich] or from using fuel of poor quality [fuel that has become stale].
What CC is a Stihl 036?
The engine moves at speeds up to 13,500 rpm when in operation, and the idle speed is 2,500 rpm. The engine displacement is 3.75 cubic inches., and this refers to the total volume the pistons can move through the cylinder.
Where is the choke on a Stihl chainsaw?
The choke position is the fourth setting on the master control lever. This setting is used to start the saw when its motor is cold. Stihl chainsaws denote the choke position using a nearly horizontal squiggle between two vertical lines at the lowest position on the master control lever.
What should the compression be on a Stihl MS250 chainsaw?
Stihl MS250 saw engine started up and runs. Checked 155 psi compression.