Learning How to Start a STIHL Chainsaw is fairly easy once you know the correct steps. Otherwise, the steps on how to start your Stihl chainsaw remain the same for both hot and cold starting. So you’ve followed all the steps on how to start your Stihl chainsaw and it still won’t start or run.
how to start stihl chainsaw ms271 Related Question:
Is there a trick to starting a Stihl chainsaw?
Press and hold the throttle trigger lockout (located on the side of the chainsaw, above the trigger) with your thumb, then move the master control (on the left of the rear of the chainsaw) down as far as it will go. This is the position you should start the chainsaw in the first time you use it each session.
How do I start my Stihl chainsaw after sitting?
Just let the saw sit for 30 min and the excess gas will evaporate. Remove the spark plug, dry it, crank over the engine a few times to dry the cylinder. Now refit the plug and try again. Set the switch to “On”, set throttle to fully open, set choke to “Off” and crank over the engine.
How do I start my chainsaw?
Try to start the chainsaw after priming the carburetor. 5. Activate the choke by moving the lever to the full choke position and pull the starter rope 3 or 4 times to start the engine. If that doesn’t work, move the choke lever to half choke and pull the starter rope, 6 times maximum, to start the engine.
Why won’t my Stihl chainsaw start when it’s hot?
When your chainsaw quits after it gets hot, you either have a problem with gas flow being restricted into the engine or with the spark. This is a common occurrence on older-model chainsaws. By replacing your spark plugs and keeping your gas lines clear you can reduce the chances of this problem recurring.