Tightening the screw will tighten the chain, and loosening will loosen the chain. Visit our Chainsaw Chains page to our inventory of available replacement chains and other chainsaw accessories. eReplacementParts.com stocks thousands of parts for many major chainsaw brands, including Echo chainsaw parts.
Insure the engine of the Poulan Wild Thing chain saw is off. In order for a Poulan Wild Thing chain saw to operate at peak efficiency the chain tension must be adjusted properly. Always wear protective gloves when handling the Poulan Wild Thing chain saw.
how to tighten poulan chainsaw chain Related Question:
What is the T screw on a Poulan chainsaw?
The screw on top — marked “T” — is for adjusting the fuel mixture while the engine is idling. Of the two underneath it, the one on the left is for adjusting the mixture when the engine is running a low speed, and the one on the right is for making the same adjustment when the engine is running at high speed.
Why won’t my chainsaw chain tighten?
Turn the tension control screw to the right to tighten the chain and to the left to loosen it. Attempting to turn the tension screw without loosening the nuts first may be the reason you can’t tighten the chain. Tighten the nuts back into place when you have the chain properly adjusted.
Why does my chainsaw chain keep loosening?
Chain Not Set Properly One of the most common reasons why your chain might be coming loose is because it was not set properly. When you go through the steps to tension your chain, you need to finish those steps by setting the tension so it won’t change as you work your saw.
What is the proper tension on a chainsaw chain?
The chainsaw chain should feel snug but still pull freely. Finally, perform a “snap” test to ensure proper saw chain tension. Simply pull the chain on the underside of the guide bar down so one or two drive links are out of the guide bar rails and release it. The chain should snap directly into position.
What are the two adjustment screws on a carburetor?
There should be two screws on the front of the carburetor, which are used to adjust the air and fuel mixture. Often these look like flat-head screws and you can use a screwdriver to turn them, adjusting the amount of fuel and air mixing in the carb.
What is the H and L on a carburetor?
They are typically labeled L (low speed jet), H (high speed jet), and I (idler jet).
Why does my chainsaw bog down when I give it gas?
If your chainsaw is bogging down when you give it throttle, this is often a sign of improper gas-to-oil ratio. If there is too much gasoline in relation to the amount of oil used, this is known as a “rich mixture” and can cause the chainsaw to run poorly.
Why is my chainsaw idling so high?
The most probable – and easiest to fix – cause of chain rotation while the chainsaw engine idles is a poorly adjusted idle setting on the carburetor. The result is that too much fuel is delivered to the combustion chamber when the throttle is released, and the engine doesn’t really slow.
Why is my chainsaw blade smoking?
This most commonly is a result of a dull chain and exerting to much pressure on the bar and chain trying to make the chain saw cut. This could also be either a lack of bar and chain oil ( tank empty, restricted oiler hole ) or an inferior type of oil that is being slung off the chain and not lubricating.
How do you adjust a Poulan Pro carburetor?
Insert a small flat-head screwdriver into the idle speed screw and turn it clockwise to increase the engine speed if it idles too slowly. As soon as the chain starts to move, turn the screw counterclockwise until the engine idles without dying and the chain stops moving for the correct idle speed.
How do you adjust a carburetor mixture?
Run the engine for five minutes at half throttle to bring it to its operating temperature. Then, turn the idle mixture screw slowly clockwise until the engine begins to slow. Turn the screw in the opposite direction until the engine again begins to slow. Finally, turn the screw back to the midpoint.