how to use rope chainsaw Related Question:
How big of a limb can you cut with a rope saw?
The longer the chainsaw, the thicker the log that you can cut through. Rope saws can range in length from 24 to 36 inches. If you only want to trim thin branches or small logs, then the smaller chain is fine.
Why does my chainsaw cut crooked?
Uneven top plates can cause a chain to cut crooked. It’s important to keep all top plates equal length. Dull cutters damaged by rocks can cause a chain to cut crooked. It’s important to remove all damage from cutters prior to cutting.
What size chainsaw do I need to cut firewood?
Many homeowners find that a 14- to 16-inch chainsaw is a good length for them. That’s long enough to limb-up trees, cut down small trees, and cut most firewood, but it’s also short enough that it’s easy to control the saw.
What is the strongest rope for pulling?
For superior strength and remarkable stretching capabilities, nylon is the rope of choice. Stronger than both manila and polypropylene, nylon commonly finds itself pulling the heaviest loads and bearing the most weight.
What kind of rope do you use to pull down a tree?
As a high-strength, low-stretch product, the Blue Ox 24 Strand Arborist Bull Rope is the ideal choice for many arborists. The 24-strand polyester [1] is durable, withstanding abrasion, chemical damage, UV rays, and water. Good knot retention is also a key feature.
How long should a chainsaw blade stay sharp?
A chainsaw may only need to be sharpened once a year if it is rarely used, but a tool that is frequently used will need to be sharpened regularly to ensure that the blade doesn’t get too dull. On average, a chainsaw blade will retain its sharpness for about 3 hours of actively cutting through wood.
Which direction do you file a chainsaw?
File the teeth from the inside towards the outside. The easy way to remember the correct direction is that the tip of the file should always point away from the engine. Hold the file at a 90-degree angle to the flat sides of the guide bar. Move the file at a 30-degree angle to the straight line of the chain.
Why does my chainsaw blade smoke?
This most commonly is a result of a dull chain and exerting to much pressure on the bar and chain trying to make the chain saw cut. This could also be either a lack of bar and chain oil ( tank empty, restricted oiler hole ) or an inferior type of oil that is being slung off the chain and not lubricating.
Do you flip the bar on a chainsaw?
Every chainsaw bar has been designed to be mounted right-side up or upside down. The reason for this is that it allows the user to extend the life of his chainsaw bar by 50%. Flipping the bar will give the heavily-used areas some relief from wear and tear.
How do you start a stubborn chainsaw?
Try to start the chainsaw after priming the carburetor. 5. Activate the choke by moving the lever to the full choke position and pull the starter rope 3 or 4 times to start the engine. If that doesn’t work, move the choke lever to half choke and pull the starter rope, 6 times maximum, to start the engine.
Why is it so hard to pull start my chainsaw?
If your chainsaw is hard to pull, here are some common causes: The pully system is snagged or stuck. The starter assembly is stuck or sticky. The housing may be damaged.
Why does my chainsaw have too much compression?
Many problems with compression are related to fuel. Old or bad fuel can cause lots of headaches with yard equipment. Try draining any of the gasoline mixture left in the gas tank and add fresh fuel. If this does not solve the problem, it may be related to excessive fuel caused by problems in the gas lines and filters.