Learning How to Start a STIHL Chainsaw is fairly easy once you know the correct steps. Otherwise, the steps on how to start your Stihl chainsaw remain the same for both hot and cold starting. So you’ve followed all the steps on how to start your Stihl chainsaw and it still won’t start or run.
how to start chainsaw stihl Related Question:
Is there a trick to starting a Stihl chainsaw?
Press and hold the throttle trigger lockout (located on the side of the chainsaw, above the trigger) with your thumb, then move the master control (on the left of the rear of the chainsaw) down as far as it will go. This is the position you should start the chainsaw in the first time you use it each session.
How do I start my Stihl chainsaw after sitting?
Just let the saw sit for 30 min and the excess gas will evaporate. Remove the spark plug, dry it, crank over the engine a few times to dry the cylinder. Now refit the plug and try again. Set the switch to “On”, set throttle to fully open, set choke to “Off” and crank over the engine.
How do I start my chainsaw?
Try to start the chainsaw after priming the carburetor. 5. Activate the choke by moving the lever to the full choke position and pull the starter rope 3 or 4 times to start the engine. If that doesn’t work, move the choke lever to half choke and pull the starter rope, 6 times maximum, to start the engine.
How does Stihl easy start?
Compared with conventional starters, the STIHL Easy2Start™ not only requires less effort, but also allows the starter rope to be pulled approximately two-thirds slower. The even pull on the starter rope overcomes the engine’s compression to minimize the strength and effort required to start.
What CC is a Stihl 036?
The engine moves at speeds up to 13,500 rpm when in operation, and the idle speed is 2,500 rpm. The engine displacement is 3.75 cubic inches., and this refers to the total volume the pistons can move through the cylinder.
Do you start a chainsaw with the brake on or off?
The chain brake should be activated when you start the chainsaw. Many chainsaw models can be started in what is known as ‘half-throttle’ position. In this position, the chain can rotate – if the chain brake is not activated.
How long to wait if chainsaw is flooded?
Many people wonder if a flooded chainsaw will fix itself? The answer is yes, but not always. By letting the chainsaw sit for about 20 minutes it will allow some of the fuel inside the engine to evaporate.