Keep your chainsaw in tip-top shape during the winter off-season. Introduction Chainsaws, like all tools with small gas engines, must be put away for the winter properly. Winterizing your chainsaw before it sits for two or three months will save you lots of time and money in repairs.
Before we walk you through the steps to winterizing your chainsaw, a question you would probably want to ask is how to use your tool in cold conditions. The first step to wintering a chainsaw is to check if the chainsaw operates correctly. Now, with tips on how to winterize a chainsaw at your fingertips, let’s look at a question of what if you don’t do it.
One of the first issues you need to think about when leaving your chainsaw or any other motor idle is the fuel quality. If you let your chainsaw or other motor lay around for more than three or four weeks, you may quickly realize the negative side of ethanol in your fuel. If you use a chainsaw as much as I do, you might even consider purchasing a bench-mounted commercial chainsaw sharpener for yourself.
how to winterize chainsaw Related Question:
Can I leave fuel in my chainsaw?
To store your chainsaw, do not run it out of gas for the winter. This allows the interior seals to dry (and possibly crack) and that is very bad for your saw.
Are you supposed to winterize chainsaws?
Chainsaws, like all tools with small gas engines, must be put away for the winter properly. Winterizing your chainsaw before it sits for two or three months will save you lots of time and money in repairs. And it only takes about 15 minutes to ensure it’s ready to go in the spring.
Should I run my chainsaw dry?
Should I run my chainsaw dry? Never run your chainsaw dry, instead use a quality gas stabilizer. A stabilizer will keep fuel fresh and protect a chainsaw fuel system from damage caused by stale gas.
How long is gas good for in a chainsaw?
What is the runtime of a Chainsaw? Depending on the type and usage, you can expect a gas Chainsaw to run between 15 and 40 min before you have to fill it up again. Most battery-powered chainsaws have a run time of up to 2 hours, but there are high-capacity power packs that will last much longer.
Can you put redex in a chainsaw?
I use this for lawn mowers, chainsaws etc, indeed anything with a petrol engine especially if it’s left without using for any length of time. “
How do you drain a chainsaw?
Move to a well-ventilated area and unscrew the lid of the gas tank on the chainsaw. Situate your plastic gas can within reach and remove its lid as well. Place the straight portion of your hand siphon into the chainsaw’s gas tank. Insert the drainage hose of the siphon into the gas can.
Why does my chainsaw leak bar oil when stored?
What causes a chainsaw to leak oil? As the oil is pumped from the tank through to the guide bar, air begins to replace the space where the oil was previously stored. If there isn’t proper ventilation of the oil tank, a vacuum can occur and reduce the flow of oil to the guide bar.
How do you hang a chainsaw so it doesn’t leak oil?
Chainsaw oil leaks occur as a result of high pressure within the tank after use. The saw should be allowed to rest for a minute after opening the cap to release all the pressure. Afterward, place the bar slightly upwards on the shelf. This will prevent oil leakage.
Can you leave bar oil in a chainsaw?
Biological oils will turn to resin if left for too long, but the ordinary run of the mill bar lube can be left in.
How often should I oil my chainsaw?
It is recommended that you grease the bearing in the tip of the bar each time you refuel. Make sure to grease the tip at the end of the day as well to help prevent moisture from entering the bearing as the bar cools.
How much chain oil should a chainsaw use?
When to Oil Gas chainsaws use about one tank of bar and chain oil for every tank of fuel, so fill the reservoir every time you fill the tank.
Should you use premium gas in chainsaw?
To start, both Stihl and Husqvarna recommend the use of high octane unleaded gasoline. Both brands of pro saws are designed to burn fuel rated at 89 octane or higher. Most regular grade fuel has an octane rating of about 87.
What do you do with an old chainsaw?
Gas and oil can be disposed of at a household hazardous waste collection site for free. Remove non-metal parts and place in the trash. Metal parts can be recycled as scrap metal.
Can you use a whole bottle of Redex?
Redex is designed to be easy to use, with clear labelling telling you how much of a bottle to use in different fuel tank sizes – so you can just follow the on-pack instructions. For example, the 250ml petrol system cleaner treats two tanks, so just add half the bottle each time you fill up with fuel.
Can redex damage your engine?
No, Redex products are perfectly safe and will not cause any damage or impairment to your car. Redex products are specially formulated to provide a reliable engine-cleaning solution that will remove harmful deposits from your fuel system without causing damage.