pro top chainsaw bar Related Question:
What length bar is best for chainsaw?
A 16 to 18-inch bar should be enough to get the job done. This longer bar length will also work for cutting down small trees or removing shrubs.
Do chainsaw bars make a difference?
Regardless of where they are made, there is a huge difference between the two brands of chain and bars. They use different formulations of steel with different hardness levels. I can tell the difference in the chains just by how they sharpen with a file.
Are GB chainsaw bars any good?
GB’s have nice hard rails and are good bars, but I don’t see them as lighter than Cannon’s in 36″ or less and above that length, the Cannon’s fat belly profile is much better.
Are Raisman chainsaw bars any good?
But even at the regular price, they are a great deal. I’m impressed that they balance so well on the 440, seem to be well made, and have a decent size Oil hole. I’ve been enlarging the oil holes on my Stihl Light bars, they are just too small. I have a 20″ Raisman bar on my Husky 257.
Can I use an Oregon bar on a Stihl chainsaw?
Chainsaw Bar & S55 Chain, Fits Various Stihl Models (105668) | Oregon Products.
How big of a tree can a 20 inch chainsaw cut?
A good rule of thumb is that the diameter of the trees you cut regularly should be no more than twice the length of the bar on a chainsaw. That means a 20-inch chainsaw can handle a 36-inch tree (remember, effective cutting length is roughly -2 inches of the bar length).
How big of a tree can a 16 chainsaw cut?
16 chainsaw would cut through a 14″ tree diameter. 10 inch chainsaw for 8″ in diameter. 6 inch chainsaw can cut a 4″ diameter.
Can you put a bigger bar on chainsaw?
Stihl’s electric saws come in three different sizes: the MSE 140 can handle a bar between 12 and 16 inches, the MSE 180 can take a bigger 18-inch bar, and the MSE 220 takes a bar between 16 and 20 inches. The little battery-powered MSA 160 is equipped with a 12-inch bar.
Can you drill holes in chainsaw bar?
Re: Drilling a Chainsaw Bar Drilling that bar may not be as difficult as you think. It will be best if you use a drill press, start with a pilot hole, and then drill to the size you need. Make sure you have a sharp bit, run at the lowest speed you can, and use cutting fluid.
How often should you change the bar on a chainsaw?
If you are looking for a general idea for how often you should replace a chainsaw bar, a rule of thumb is to replace the bar of your chainsaw once after you have gone through three chains on the same bar.
Why is my chainsaw bar smoking?
This most commonly is a result of a dull chain and exerting to much pressure on the bar and chain trying to make the chain saw cut. This could also be either a lack of bar and chain oil ( tank empty, restricted oiler hole ) or an inferior type of oil that is being slung off the chain and not lubricating.
Where are GB bars made?
GB Forestry Australia is based in Derrimut-Victoria, where its office and manufacturing centre are located. GB has been manufacturing guide bars and associated products since 1959.
Where are GB chainsaw bars made?
A producer of chainsaw and harvester bars for all of his life, he is the owner of GB Product Development, the driving force behind GB bars, manufactured in Australia and China and sold across the world, with distributors in over 70 countries.
Where is raisman chain made?
The raisman carb kits say made in Brazil.
When should you throw away a chainsaw chain?
The chainsaw pulls in one direction, which results in a crooked finish. Blunt cutting teeth on one side or uneven teeth lengths usually cause this. The teeth has hit rocks or dirt and broken. If you notice the tops of the teeth are missing you will need to replace the chain.