To clear excess fuel from the carburetor, place the choke lever in the Off position, hold the throttle trigger fully open and pull the starter rope 5 or 6 times. Try to start the chainsaw after priming the carburetor. Activate the choke by moving the lever to the full choke position and pull the starter rope 3 or 4 times to start the engine.
Here, we look at the top 11 reasons why your chainsaw won’t start. Another common reason a chainsaw won’t start is that the sparkplug is old, dirty, damaged or not correctly attached. If the temperature is too low, it can make it hard to start a chainsaw.
If the operator has repeatedly been trying to start the chainsaw through the recoil starter system, they may have accidentally flooded the engine with fuel. If you believe fuel has flooded the chainsaw engine, pull the starter cord several times while holding the throttle, dry and replace the spark plug, and then try starting the chainsaw again. Gasoline will start to deteriorate if left unused and sitting, so if the chainsaw hasn’t been started in a while, be sure to check that old fuel is not collecting inside the chainsaw.
my stihl chainsaw is hard to start Related Question:
Why is a Stihl chainsaw so hard to start?
Problems starting a Stihl chain saw can be related to gasoline storage, spark plugs, and incorrect starting procedures.
Why is my chainsaw hard starting?
A fuel issue is one of the most common reasons why a chainsaw won’t start. If the operator has repeatedly been trying to start the chainsaw through the recoil starter system, they may have accidentally flooded the engine with fuel. A common indication the engine has been flooded is the smell of gasoline in the air.
How do I make my chainsaw easier to start?
Try to start the chainsaw after priming the carburetor. 5. Activate the choke by moving the lever to the full choke position and pull the starter rope 3 or 4 times to start the engine. If that doesn’t work, move the choke lever to half choke and pull the starter rope, 6 times maximum, to start the engine.
Why is my Stihl chainsaw not firing?
Dirty or clogged fuel tanks, dirty fuel filters and lines, loose fuel hoses, dirty air filters and a dirty carburetor can all restrict fuel flow. Check, clean and replace all the fuel system parts before moving into the internal engine, as gas problems create a majority of starting problems.
How long to wait if chainsaw is flooded?
Many people wonder if a flooded chainsaw will fix itself? The answer is yes, but not always. By letting the chainsaw sit for about 20 minutes it will allow some of the fuel inside the engine to evaporate.
Can you push start a chainsaw?
The biggest advantage of an electric chainsaw is that you don’t have to pull a cord and it needs minimum effort to get it started. You can start it by just pushing a couple of buttons and there is no throttle to open.
How do you clean the carburetor on a chainsaw?
Let the chainsaw run at low RPMs/idle for a while. This is to let the cleaner run through the carburetor, the fuel lines, and the idle engine. The cleaner will wipe remove the gummy residue blocking the components to create a clean passageway for the air and fuel. As the RPMs begin to increase, turn down the idle knob.
Will a flooded engine fix itself?
Will a flooded engine fix itself? No. You have to take appropriate measures to restore the fuel and air balance in your car’s engine.
How long to wait if engine is flooded?
Perhaps the best remedy for a flooded engine is time. Simply open the hood of your car and let excessive fuel evaporate for as long as you can. After about 20 minutes try starting your car again without hitting the gas pedal.
Where is the choke on a Stihl chainsaw?
The choke position is the fourth setting on the master control lever. This setting is used to start the saw when its motor is cold. Stihl chainsaws denote the choke position using a nearly horizontal squiggle between two vertical lines at the lowest position on the master control lever.