An electric motor that doesn’t need to be serviced for a long time helps to keep the work surface clean.
Staples can be set to the correct depth of drive without having to use a tool.
Sequential or contact actuation can be chosen as the trigger.
It tells you when to reload when there aren’t any staples left in the magazine.
Use the rear exhaust to keep the fumes away from work.
In this case, the DEWALT DWFP1838 has 18 GA of power. Finish the stapler. It has a long life and doesn’t need to be cleaned or repaired. A tool-free way to adjust the depth of drive. Selectable button. Lockout with low staple. This is the exhaust pipe on the back of the ca.
Then I tried to use it. It didn’t work. I didn’t do what I should have done. When I opened the stapler to load it, I thought the staples would go over the support bar and spring that come out of the back. This was a problem for people who want to know all about these shady things. Staples will fit over it, but don’t push them all the way into the tool when you close the “magazine” (as the instructions call it). To be fair to myself, DeWalt is partly to blame because I read the manual after I didn’t know how to use the tool. There is a story about how a person opens the magazine, staples are put in, and then the magazine is shut down. The picture next to the tool shows the tool with the magazine open (but no arrows pointing to the part they mean by “magazine”. So, based on what they told me, my process might have been correct. I called the seller “This won’t work. What’s next?. Seller: Send it back on their dime. I did, and I got a quick refund from them. The first DeWalt tool I bought must have been a mistake, because I bought another one. I open it, try to put the staples in the wrong way again, and I’m still stumped. What’s going on? I don’t know. They come in a group that is too big to fit over this spring rod. Why didn’t they make it so the staple group (cluster) was the same size as the rest. A better term for this would be “fits like a glove. In order to figure out what this means, I turn the tool over. I see a gap on its bottom. As close as possible to where the staples would g. And it’s about the size of a bunch of staples, too. You don’t think.. Yes, the group jumps right into the magazine. The tool works great, and my project is done in 30 minutes. You should know that the magazine is accessible from the bottom of this tool, after you slide open its cover plate. This means that the magazine can only be accessed from there.
