Smart Point Technology: The electric brad nailer is easy to use because it has a smaller nose than other BOSTITCH nailers and no need to compress the contact trip to start the tool. This makes it easier to place nails.
The 18 gauge brad nailer can drive 18 GA brad nails from 5/8-inch to 2-1/8-inch in length with ease.
Oil-free operation cuts down on the chance of oil stains because it doesn’t use oil.
To get the nail out, you don’t need a tool.
Use Dial-A-Depth to make sure that brad nails are countersunk with precision.
For sequential or contact operation, there is a trigger system that can be changed.
Also, there is a rear air exhaust and a belt hook with an integrated pencil sharpener.
Kit: Nailer, 1/4-inch Air Fitting, Carrying Case, and Extra No-Mar Tips are in it.
To use this Smart Point 18 Gauge Nailer Kit, you can use it for cabinetry, upholstery and paneling, among other things.
When you choose a trigger system and countersinking options, make sure they work best for your project.
If you want to be fast and strong, use this Smart point 18 Gauge Nailer Kit!
Drives very well, with a head that won’t get scratched.
To be honest, I bought the high-end Makita from Amazon and was very disappointed. I sent it back because it didn’t work well.
See what other people say about that unit in the reviews.
It couldn’t toe nail (nail at 45 degrees) on any brads that were longer than 3/4 of an inch “This while having to run the gun at and just above its maximum pressure to get it to work (not good for the life oif the gun).
There are also softwoods that have been shot with a gun almost every time I drive.
I love all of my other Makita tools, but I’m sad to see them make a bad one.
This is why I was looking for a new brad nailer. The Senco I already had was not able to toe nail the long brads I needed to drive (2 inches and up).
I have three sets of stairs and balconies that I need to finish carpentry on. I will be driving hundreds of toenails into the balusters.
Because the nails were only partially driven in, they would have taken a lot of time and aggravation to hammer and nail punch each one. Also, they would have had to fill and sand all the holes that the nail punch would make.
For $30, I decided to buy the Bostitch and give it a go.
Man, man, what can I say about this?
There are no mars “Brads go through oak balusters and oak treads, with a perfect level of counter-sink, while the gun is only running at about 80% of its max pressure.
I love this Bostitch brad nailer gun.
A few extra dollars is worth it, and it is worth it again and again.
I think you will be happy that you did.
I hope the review helps you make a decision about what to buy next.
If you agree, give it a thumbs up.
