Powerful motor and 6 different speed. If you need to cut wood, plastics, plywood, PVC pipes, or tile quickly, this saw has a 500W copper motor that makes it easy. There are 6 places on the speed dial that can be used to change the speed from 3,500 to 6,500RPM. This lets you choose the right speed for different tasks.
This is a light-weight design with three blades. . To put it another way, this small circular saw weighs only 4.1 pounds, which is 50 percent less than a normal circular saw. It is easy to store with the bag that comes with it. For cutting wood, it comes with a 24T TCT blade, and a 44T HSS blade for cutting soft metal. A diamond blade for cutting tile comes with it, too.
] [Easy CUTTING AND ADJUSTABLE DEPTH. – It comes with guide rails, making it easy to cut in a straight line. Slide strips that aren’t very slippery make sure the mini circular saw moves smoothly over the track. An easy-to-use depth gauge lever lets you change the cutting depth from 0 to 22mm(7/8 to 1-1/8 inches) “.
A handle made of soft rubber and a secondary handle on the other side give you more control, less fatigue, and are both safe. Dust ports and saw dust pipes are also built in, so you can use your vacuum to keep your work area clean. When you press the power button, the blade can only be pushed out. This makes it safe to use.
Mini Circular Saw: 1 x Mini Circular Saw. 1 x 24T TCT Blade, 1 x 44t HSS. 1x Diamond Blade, and 2 x 15t HSS “It comes with Guide Rails, a Hex Wrench, an Angle Ruler, a Scale, a Dust Exhaust Pipe, and a Storage Bag that makes it easy to carry around.
Good job on the saw. It’s a tool that works OK. This tool seemed to be a smaller version of my expensive track saw. I bought it because it looked like it. For a small job, I don’t want to use my track saw “In this case, you can cut on wood. Because the plastic slide for the track has a 1/16th-inch gap, you have to hold it against the track’s left edge while cutting or your cut will go off. There is only one side of the dust port that is connected. It broke off after a few times of using it. a very small 1/4 is what you need “hose for your shop vac to connect to (not included). I want to see a cut line that is in line with the blade. Because of this, it is hard to keep the information correct. If you don’t turn on the motor, you can’t get the saw in line or ready to cut. This makes it more difficult for you to get the cut right. You should know that it takes some time to get used to it. I got some great cuts and will keep using it.
