CNC Z-Axis router mill touch plate tool setting probe is a new hot item in the milling business.
An auto-check instrument for setting the tools on a CNC router engraving machine is about 1.38 inches long.
The Z-axis tool setting touch plate on the CNC router mill is used to set the tool.
The effective surface of the blade is about 25mm /0.98inch (diameter.
Size: 1.38 x 0.79inch / 3.5 x 2cm (D x H.
Description.
Wire and metal make up the rest of the thing.
Specification.
Size: about 3.5 x 2c.
The effective surface of the knife is about 25mm.
Line length: about 110c.
Machine Tool Setting Touch Plate in a CNC Route.
Probe: CNC Z Axis Router Mill Touch Plate Tool Setting Prob.
These touch plates make setting the height of your tool and zeroing your z-axis a piece of cake. These can be used with many different types of CNC controller software. They work well.
It can be linked in two ways.
If your interface board has a limit switch port or other probe port, you can connect it to that port and use it to measure things.
If your interface board doesn’t have that port, but your driver board does, you can connect it to the limit switch port on the driver board.
then you need to set up the probe and the Auto-Tool-Zero. You need to do this in the Configuration-Ports and Pins section. In the attachment, you will find the code. You can change it to meet your needs.
Usage.
There is a wire that connects to the control panel.
The clip and the control board’s GND (negative) are linked.
When the knife has a clip, the tool can be held in place during the process.
When the tool comes into contact with the knife, the process is over.
How many of these are there.
Note.
Please allow for a 0-1cm error when measuring manually, thank you. There may be a difference in the color of the item’s picture because of how different monitors work. “Thank you!.
Not worth it. I thought this would be spring-loaded or have a soft base to protect the bit. This is nothing more than a contact point on a hard plastic base, and it doesn’t protect the bit.
