Rotary hammer and Drilling dust-extraction attachment-for drilling diameters from 3/8 In. to 1-3/8 In., but can be used up to 2-3/4 In. by taking out the brush ring.
The vacuum dust extractor is compatible with standard hose sizes from 26mm to 39mm (1-1/8In.1-1/4In.1-1/2In.1-3/8In.), and it can fit 64mm (2-1/2In.) by taking the rubber band off.
Rubber seal keeps suction to the wall and keeps dust inside.
The two air chambers can both collect dust and suction the wall while they are being used.
The hose receiver can be turned so that the hose can be moved where it needs to be.
It is very easy to use this dust collector in just a few seconds. You can put the drill buddy on any flat surface of your choice, press the vacuum button for an instant and safe seal, and then start to drill. After you’re done, just click the button to stop the suction and throw the dust into a bin so you can move on to your next project.
It looks and feels like high-quality plastic, and the suction is good. When you use a large bit that leaves a lot of residue, there is a small hole where a little fine powder comes out.
This opening makes the amount of dressing on vertical walls go down a little. So they should make sure that their work is better.
