This enclosure is made for all 3018 CNC routers.
The enclosure can cut down on the noise while engraving and keep the dust from shards.
It makes it safe for you to watch the engraving process from the clear acrylic.
The enclosure needs to be put together. When it’s done, it will take about 15 minutes to put together.
Inches: 19.29×17.32×12.8 inches/49x44x32.5 cm.
For all 3018 CNC machines, there’s a clear enclosure.
All but one of the steps to put together were very easy to follow. It’s important to put the hinge on the front glass before you put the hinge on the frame. They added a few extra screws, which is always a good thing. Well made and thought out, with a magnet to hold the front door in place. Some of the acrylic parts had brown covering and most of them had clear covering. All of them were covered in film to protect them. A few very small scratches were there, but they were not very noticeable. In the end, it was worth the money.
