It comes with a chuck.
A 13-amp motor has enough power to drill holes of all sizes.
Max 1750 rpm-inch high, clutch-inch low gear range.
a 90-degree turn to the left to the righ. The Roto-Lok handle gives you the most comfort while you work.
Having a removable side handle gives more control.
An impact-resistant case is also included.
An overview of what this item is abou.
Straight Drill with a 1/2-inch Chuck, 450/1750 RPM Drill Speed, 13 Amps at 120 Volt, Reversing, Triple Gear Reduction. Bearings for Ball and Rolle. Size of Spindle: 5/8-16 In. Tool Length: 22 In. Tool Weight: 14.7 Lb. Cord Type: 8 Ft, 3 Conductor. Is made with a T-Bar Front Handle, Side Handle, Gear Shift Knob with Trigger Switch and a Chuck Key and Key Holder. It comes with a Chuck Key and Key Holder, as well as a Side Handle and Plastic Carry Case from the manufacturer.
Make sure you have the power and speed to drill holes of any size with Milwaukee’s 1/2-inch Super Hawg right angle drill. The 13 amp motor has two speeds: 1750 and 450 rpm. It has a clutch in the low gear range. In this case, “comfort grip” is better. The Roto-Lok handle has three positions that can be rotated 90 degrees to the left or right for maximum operator comfort, no matter what the job is. Package comes with a tool, a side handle, and a case.
This super-hawg drill was the one I found after a lot of looking around. It’s very strong and can do a lot of work. For myself, I like to buy just one tool for the job and not have to have different tools for light and heavy duty. I also like my tools to last, and I don’t mind paying a little extra for the better-built pro-level tools. This tool is very heavy duty, so make sure you don’t have a bad back if you want to buy it. It’s also exactly what I look for in a tool. For example, it can do just about anything for its job and isn’t limited by under-power with large diameter holes, for example. Until now, I haven’t used it very much. I used it to cut a few 2.5″ holes through hardwood floors and the subfloor, but it went through them like butter. As well, I was very pleased with the lack of kickback. Whenever I use a hole saw with my 24v Ridgid cordless drill, it always gets stuck and kicks. I have to put the battery back on the charger for a few seconds to get the voltage and polarity back to where they should be. Again, I must stress how important this drill is. As a bonus, I like that all of the handles can be removed, even the short one on top of them (I was cutting holes below an elevated fireplace hearthstone for in-floor speaker brackets and had to remove the top handle to get the drill to fit underneath). The whole front or top part of the drill is made of rubber to give you a lot of different grip options if you don’t want to use the handle. The rear handle can also be turned. A nice long cord also has a plug that lights up, which is a great feature for a tool like a long extension cord. This drill was made in China before it was made in the United States. Other people have said that this is bad because the drill was made in China before it was made in the United States. However, this drill is better than the cheap Chinese tools you get at the discount tool stores. Even though they may have sent some jobs to other countries and I haven’t had the chance to own a US-made hawg, Milwaukee still makes a high-quality tool with this drill. Even with Prime shipping, Amazon had one of the best prices.
