Exquisite craftsmanship, small size, light weight, and easy installation.
There is a lot of flow, a stable performance, and a lot of efficiency.
All drill chucks will fit. You can get a pump with an electric drill.
Made out of moulded plastic that can withstand heat and corrosion.
This self priming drill pump can be used with a corded or cordless drill, and it fits most electric drills. It can be used to empty sinks, aquariums, pool skimmers, and much more.
It’s made of plastic.
It has an 8mm round shank.
It takes 3 meters for the self-priming to work.
Rate: 1800 (m3/h.
Packet: 106 * 74 * 80mm, or 4.2 * 2.9 * 3.1in long.
Package: 252g / 8.9ounce.
Instructions for operating.
Before each use, put a few drops of lubricating oil in the pump inlet and flush it with clean water after each use.
Airtight and as short as possible: 2. Make sure the inlet hose doesn’t leak. A 3m inlet hose should not be used.
It will be easier to keep the pump going for a long time when you use a strainer on the inlet line when pumping hard water or liquids that have a lot of solids.
4. The pump should be mounted to a surface for safety and ease of use.
Finally, mount and start dil. Watch the inlet tube to make sure the fluid is drawn into the pump in 15 to 20 seconds. Make sure that the inlet tube is properly attached to the inlet pump if it isn’t already done.
Package with.
There is only one drill pump.
Two hose clamp.
The two connectors have two of them.
