3 Modes of Us. When you press the button, you can choose between drill mode (rotation only), hammer mode (chiseling only), and hammer drill mode (hammering and rotation). It can be used to drill and chip into wood, steel, concrete, and masonry with different drill sizes. Plus, vario-lock has the best chiseling angles.
SDS-plus Chuck & All Drill Bits Se.
The SDS-plus quick change drill chuck made it easy for you to keep your drill bits in place. 1/2″ is the diameter of the chuck on this impact drill. It can drill up to 1-3/16″ deep (30 mm). To make things easier, there are more drill bits (6/8/10 mm), 2*Chisel (Flat and point), 2*carbon brushes, a grease with a carry case for easy use.
Versatile Speed Trigger and two-way switc. The variable speed trigger lets you control the speed with your finger, so you can set the speed for different applications to get the best results. In addition, there is a forward and reverse switch that makes it easy to get the drill out of the way and a lock-on button that makes it easier to work for a long time.
It has a high-performance moto. 1100W heavy-duty copper motor can deliver a lot of power with an 0-4000/min impact rate and 1100 rpm no-load speed to help you finish the hard work. Users can be safe when a machine is under a lot of torque. A safety clutch can do this.
360° Rotating Handle & Easy Operatio. An auxiliary handle is very flexible and can move around 360 degrees with more control and comfort. It can also be put in and taken out quickly without any tools. The detachable scaled depth gauge helps you figure out the correct drilling depth.
For the price, I was very happy with this tool. With a 20° tile removal tool attached, we were able to remove the tiles with very little effort. If we took our time, we could even save some tiles. It also took very little effort to get rid of the mortar. The concrete below looked almost like it had never been used. I haven’t tried the drill setting yet, but I’m sure it will be just as good. I’ve never used it before.
After a few tries, you get used to where the lever goes for full hammer force. The case is useful, but the latches aren’t very good. That’s not important, though, because it doesn’t matter. Overall, I was very pleased.
