1pc 105 Degree Screwdriver Bit Holde.
It’s good for the Wrench because it can be used with a drill, a drill that can be recharged, or a manual wrench.
Connect to the standard hex screwdriver to be light and fast.
1/4 inch Magnetic Bit.
In this case, the parts were made of die cast metal.
The material is stainless steel.
Silver is the color.
Size:As the picture shows.
A 1/4in hex screwdriver is the best tool for this job.
A package comes with.
There is only one screwdriver here.
When I’ve used an impact driver, I’ve used a few different 90-degree adapters. As long as you need three hands to use any of them, this one is about as good as any. There are other ones that are bigger. This one, on the other hand, is small. Sheet metal screws were used to drive into a sheet metal heat shield above a gas hot water heater vent. I couldn’t get the other things I’ve used in there. Product looks like it was made well. There are no burrs that will cut your fingers when it spins out of control for the first time (from lack of said third hand. The hex shank could have been longer. Good tool that I would buy again.
