a set of four “100 mm Tilting Rotary Table and a 65 mm 3 Jaw Self Centering Chuck with Back Plate and T nuts are included.
This product has the ability to tilt between 0-90 degrees and can be locked in any position.
The table is graduated in all directions. Worm Gear Ratio is -1:36, which means that one rotation of the handle will turn the table by a full ten degrees.
Description: This product has the ability to tilt between 0-90 degrees and can be locked in any position. The table has a 100 mm diameter and is graduated 360 degrees. Worm Gear Ratio is -1:36, which means that one rotation of the handle will turn the table by a full ten degrees. Cente. 2-5/8 inches tall when standing in the vertical position ” (66 mm approx. The hand wheel is graduated in 10-minute increments and has the option of being reset to zero. It is possible to mount it in both horizontal and vertical positions. A 3 jaw saw with a 65 mm blade is included. Tnuts and a plate are used to center the chuck, which is self-centered. The back plate has been drilled in such a way that it can be used with both a 3 and a 4 slot Rotary talbe.
It appears to be in good condition. For accuracy, I gave it a three out of five stars, but I haven’t machined anything yet. There were no 5M screws for the T nuts to be found. These guys lost a couple of stars as a result of my unplanned trip to the hardware store. In addition, only two T nuts were provided. Four people can be accommodated on the backing plate. Now I’ll have to make a couple more of them so that the chuck back plate has a stronger hold on it.
