When it comes to a significant portion of the work, it can replace the petiole small wheel with no dust pollution.
High product processing quality and finish, as well as the ability to process a variety of high-precision mold cavitie.
Carbide burrs are primarily used on pneumatic or electric tools, with some use on hand tools. The required rotational speed ranges from 6000 to 50000 rpm.
High production efficiency, with processing efficiency several times greater than that of a file and nearly ten times greater than that of a small wheel stalk.
Mold manufacturing, mechanical chamfering and deburring, welding, and metal and non-metal processing engraving, among other things, are all possible applications.
These carbide grinding bits consume metal at a rate that defies belief. If you take good care of them, they will last a long time. Steel and bronze are the materials I use to clean up welds. Doing the inside of a small hole is the only time I’ve had these bits ruined in a short period of time. If you’re pressing too hard and the bit jumps from one side of the hole to the other, the shaft may become brittle and break off. When this occurs, you will notice a bad vibration, and your bit will be rendered useless. It’s past time to get a new one. My recommendation is to take down metal as slowly and gently as possible, if at all possible. I would not purchase any other type of bit than a carbide bit. The ones you can get from Harbor Freight are completely ineffective. I keep several of these on hand simply because they are so fantastic, and I occasionally find myself in a situation where I absolutely require them because nothing else will do.
