Improved performance thanks to a powerful 7.0 AMP motor.
Suitable for drilling in a wide range of materials at a variable speed (0-950 RPM).
The use of a retractable belt clip allows for operation in confined spaces.
Rubberized grips that have been ergonomically designed for comfortable operatio.
The side handle can be rotated 360 degrees for added comfort and control.
Reversible, variable speed transmission. Belt clip that retracts, ergonomic rubberized grips, a large trigger switch, a comfortable side handle that rotates 360 degrees, all ball and needle bearing construction, brushes that are easily accessible, and double insulation are just some of the features of this tool. Specifications: capacity in steel 1/2″, wood 1-1/2″; 0-900 RPM no load speed; weighs 4.8 lbs; 0-900 RPM no load spee. Included are a chuck key and a side handle.
I was in desperate need of a 1/2 inch corded drill after my trusty Makita 6303, which had been in service for more than 20 years, became inoperable due to operator error (my fault).
A contractor who worked for me purchased a knockoff of the HF holeshooter, and I snorted and laughed at him. Within minutes, a spade bit was used to cut it in half (literally; he was lucky that he didn’t get cut by the piece of plastic).
He then purchased a Milwaukee holeshooter 1/2 inch drill (Milwaukee 0234-6 Magnum), which, despite the fact that it was manufactured in China, was of high quality. The size is ideal, and the surface is smooth. The only drawback to that drill was that the trigger was so long that it was nearly impossible to let go of the trigger and not the handle if you got into trouble with the drill (which happens with these powerful drills and spade bits). So I went out and bought one of those.
However, mine made terrible clackety gear sounds (spotty quality control in Chinese tools, in my opinion), so I returned it.
I then purchased this dp4000, despite the fact that I had never seen one before and despite liking Makita in general (lots of makita tools).
I haven’t had a chance to use it much yet, but my initial impressions are very positive.
pros.
very smooth and silk.
excellent trigger control, ranging from slow to fast.
grip and hand positioning that is extremely comfortabl.
Considering the circumstances, this is quite light.
action with a chuc. The chuck key is not excessively large and fits most of my other Makita drills, including 3/8-inch ones.
The handle is excellent, and the ease with which it can be attached and detached in a variety of positions, as opposed to the traditional screw-in handles, is extremely convenient.
convenient location for the reverse switch leve.
This particular grade of makita is manufactured in Japan.
disadvantages of using an e-mail address to send a message (minor.
a little long, but not a big dea.
Unlike the Milwaukee, the cord is not easily replaceable (although I am not sure I see that as a negative really.
This size drill has a lot of after run, which is to be expected given its inertia, so that is not a negative point. This drill is not intended for use with standard screws.
There is a small amount of runout in the chuck. It does not appear to be a problem at this point.
So, with the exception of a very slight chuck runout, it is even nicer and more industrial than I anticipated (I am pretty picky with tools).
It’s a pleasure to hold and a significant improvement over my 6303, which I enjoyed using until I got this drill.
Please note that this drill was chosen in part because I desired something that could turn at least 850 revolutions per minute to allow the use of smaller bits as well. It is recommended that people who require even more grunt and control at extremely low rpms consider drills with a maximum speed of say 500 rpm or less.
