A set of aluminum wheels made by CNC machined for Belt Grinders.
Made of 6061 aluminum, which is the best aluminum.
An easy and safe way to mount things.
3 heavy-duty 12″ bearings were put in. Back to Back in each wheel to get the most life out of the bearing.
In order to mount the idler and tracking wheels, you need a 3″ long bolt (not included) that is 12″ long.
Belt Grinder with a 2″ x 72″ wheel. It’s a machine that grinds . 10.5-inch Driv. 5/8-inch bor. Track 4. Set of 2″ Idler Wheel. Description. There is one 5.1″ diameter Drive Wheel on the car. In this case, the drive wheel was made by CNC. It has a 5/8″ bore (H7 tolerace). Bore has a 3/16″ key way and a set screw. This is how it works. The wheel is 2.2 inches wide. An inch-long bore. The surface of a wheel is truly crowned so that the belt doesn’t fall off the wheel. Please look at the wheel’s sketch to get the exact dimensions of the wheel. The diameter of two (2″) is the sam. Each wheel is made by hand and has three 1/2″ bearings on it. Bearings with a lot of power 6201-1/2 RS are used. They are rubber-sealed to keep out dirt. There are two bearings stacked on top of each other back to back (best combination). A standoff (sleeve) that is 3/8″ wide will raise the wheel of the mounting plate so that it is level with the ground. In tests, the best way to keep bearings from breaking is to use this bearing combination. It allows you to tighten the screws on the mounting bolts without putting any axial pressure on the bearings (ball bearings should not bear lateral load. One inch (four. Each wheel is made by hand and has three 1/2″ bearings. Bearings with a lot of power 6201-1/2 RS are used. They are rubber-sealed to keep out dirt. There are two bearings stacked on top of each other back to back (best combination). A standoff (sleeve) that is 3/8″ wide will raise the wheel of the mounting plate so that it is level with the ground. In tests, the best way to keep bearings from breaking is to use this bearing combination. It allows you to tighten the screws on the mounting bolts without putting any axial pressure on the bearings (ball bearings should not bear lateral load. In the United States, if you pay by 2 PM Central Time, your order will be shipped the same day (USPS Priority Mail)
