Most sanding belts are now made with a diagonal splice joint that is held together with a strong piece of special tape. Then use CA adhesive to bind the bias binding tape to the cleaned edges of the sanding belt you want to make or repair. His solution is to store new and used belt sander belts in sealable freezer bags until he’s ready to use them.
“First, peel the remaining factory tape off the belt splice. Cut a piece of cloth bias tape about 2” longer than the width of the belt. Lay one end of the belt, grit-side down, on the bench; then apply cyanoacrylate glue to the end of the belt. Wrap the belt around and repeat the gluing process to reconnect the ends of the belt.
Yup Drew, Lap joint belts have arrows, so the joint does not catch on the platen. Tod & Wes, I had heard that the shelf life of belts is not at all too long. Wes, I am thinking that the tape used to join these belts looks a lot like fiberglas strapping tape.
Test your joint before putting your newly glued sander belt on your sander. Unfortunately a lot of glues will not hold when used with a belt sander due to the extreme heat and tension your belt sander is under when working and it is best to buy a new belt that is designed for your machine, but if you need a quick repair to get your machine up and running again this is an option. You need something that has great strength and durability as your belt sander is a very hard working machine and your belt is going to be exposed to a lot of heat and tension.
how to glue sanding belts back together Related Question:
How do you glue sanding belts back together?
Lay one end of the belt, grit-side down, on the bench; then apply cyanoacrylate glue to the end of the belt. Lay half of the bias tape’s width on the glue, place waxed paper over the tape, and use a weight to press down on it for about 30 seconds, or until the glue sets.
Can you’re glue sanding belts?
Tim Inman: There are adhesive bonding tapes available to help you do exactly what you are wanting done. They are made and sold for building and repairing abrasive sanding materials. You can also mend or make abrasive belts by this DIY method: Obtain some bias binding tape from a fabric store, or you can make your own.
What tape is used to join sanding belts?
Apply the Scotch 8959 tape by using a small piece of swimming pool noodle or other firm foam/rubber like a squeegee pressing firmly and leaving overlap on both ends, make sure there are no air bubbles and the tape is perfectly flat covering both splice ends equally.