With the Bora QuickCut, you can use a single tool to do a lot of different things. All with the help of a saw guide. This circular saw accessory doesn’t need a miter saw or more complicated jigs because it has a lot of different angles on it. Pre-set angles: 22.5°, 45°, 60°, and 90°. You can cut wood or soft metals with unmatched precision at each of these angles.
When you use Bora’s cutting guide, you’ll avoid having to figure out how to use a typical tri-square. You can mark, measure, and cut with ease. Measure the angles for framing and crown molding without having to do the math. The ruler also has imperial and metric measurements on it.
You can hold on to the large and curved handle with ease because it’s soft and easy to grip. As long as you have the QuickCut, you can keep a firm grip on your circular saw without your edge guide moving.
Bora’s QuickCut saw guide is made of strong aluminum and has ruler marks that are easy to read. Make long, straight cuts with a 14-inch (35.5cm) guide rail. It’s 16 inches long.
When it comes to cutting-edge power tools accessories, Bora is the best.
Use the Bora QuickCut saw guide to finish any DIY project with precision. This small tool gives you more length and flexibility than most cutting guides, but it still fits in your pocket. Like a Swiss Army knife for cutting guides. If you’re a woodworker who likes to do things at home, this is a great gift for you. Use the QuickCut by Bora to get precise cuts every time, without having to deal with all the extra work.
The primary reason I purchased the Bora guide was to align my circular saw quickly with my cut line and execute a cross cut. It doesn’t work with my saw because the blade guide is only 6″ long. Makita XSH08 has a bigger base because it can be used for two things at once (traditional circular saw and ability to use with a track base).
Also, setting the angle or straight cut you want isn’t easy, and it takes a long time. Unscrewing the base to move the rail to the right angle takes more work than it should. Also the use is cumbersome, there is a small rail u see the base that aligns o. As the board edges, it’s hard to get into.
