The Freak impact driver has a 1/4 In. quick-change hex shank and a 1/2 In. square drive. It can be used with bits and sockets, and it can also be used to drive screws.
Innovative impact driver: It doesn’t need socket adapters, and a variable-speed trigger gives the user control when driving fasteners.
With an 18-Volt battery, you can get 1,600 In-Lbs of torque, up to 3,600 impacts per minute, and 0-2800 RPM with this tool.
The hammer-and-anvil system was made to have the most impact energy.
A single-focused LED light is on the bottom of the driver for great lighting.
The BOSCH Freak is half a wrench, half a driver, and all power. When you use the GDX18V-1600 18V 1/4 in. and 1/2 in. Two-in-One Impact Driver, you can get the job done. It has a 1/4 in. quick-change hex shank holder with power groove for bits, as well as a 1/2 in. square drive for sockets. This new tool allows you to do a lot of different things without having to buy socket adapters for your cordless drill. 0-2800 RPM, 1,600 In.-Lbs. of torque, and 3,600 impacts per minute are some of the things that the impact wrench and driver’s efficient, powerful cordless motor can do. The variable-speed trigger allows you to drive at the right speed. The driver has LED lights that can be used to make the work area brighter. You get one 18V 2.0 Ah SlimPack battery and a charger when you buy the kit.
June of 2016 is when I bought my Bosch cordless drill. I think it’s great. Heavy, but powerful and good with battery life. During July, I bought this impact driver to go with it, because I knew there were going to be some projects. I was very happy with how things went.
When I started, I made a wooden ladder for a friend’s extra room on the top floor. In this case, it was made of 2×10 hickory with 16×1 mortises that had been cut out “Hickory steps that are thick and strong. One of the steps is held in by a 1/4″ x 3” fastener B001OEJULG. This driver smashed through about 40 of those screws into solid hickory before it needed to be charged. I was so excited.
When she moves into her new home, she will be working on a big staircase that needs to be changed. It was today that we took all the old treads and risers off, and we used that material to make new risers that were thinner than the old ones. A lot of deck screws will be used to keep her new stairs in place. Her new treads and risers are made of solid maple. This driver fires three shots “Deck screws go through wood like butter. The only thing I don’t like is how loud it is, but that’s to be expected.
