How to Start a Chainsaw That’s Been Warmed Up.If you’re taking a short break from using the chainsaw, then you can restart it without using the choke since the engine is already primed with fuel. If you haven’t purchased a chainsaw yet, I encourage you to take a look at my best gas chainsaw reviews. Check out my best 18 inch chainsaw page and best 16 inch gas chainsaw page to see what you can get.
The chain brake should be activated when you start the chainsaw. Release the front handle and allow gravity to bring the chainsaw down, rotating around the rear handle, towards the stump. Hold the chainsaw firmly by the front and rear handles.
A Husqvarna chainsaw will be different from an Echo chainsaw, and you might not know how to operate the one you are about to start. Before starting a chainsaw, make sure you are wearing all the proper protective gear, including chainsaw chaps, eye goggles, ear protection, chainsaw gloves and protective footwear. Don’t drop start – A drop start is where you hold the chainsaw in one hand and pull the starter rope with the other.
chainsaw how to start Related Question:
Do you start a chainsaw with the brake on or off?
The chain brake should be activated when you start the chainsaw. Many chainsaw models can be started in what is known as ‘half-throttle’ position. In this position, the chain can rotate – if the chain brake is not activated.
Why is it so hard to start a chainsaw?
The chainsaw’s engine is flooded with fuel. A fuel issue is one of the most common reasons why a chainsaw won’t start. If the operator has repeatedly been trying to start the chainsaw through the recoil starter system, they may have accidentally flooded the engine with fuel.
How do I make my chainsaw easier to start?
Try to start the chainsaw after priming the carburetor. 5. Activate the choke by moving the lever to the full choke position and pull the starter rope 3 or 4 times to start the engine. If that doesn’t work, move the choke lever to half choke and pull the starter rope, 6 times maximum, to start the engine.
Why can’t I start my Stihl chainsaw?
Dirty or clogged fuel tanks, dirty fuel filters and lines, loose fuel hoses, dirty air filters and a dirty carburetor can all restrict fuel flow. Check, clean and replace all the fuel system parts before moving into the internal engine, as gas problems create a majority of starting problems.
What does the choke do on a chainsaw?
The choke position increases the richness of the air and fuel mixture the carburetor sprays into the cylinder. With the master control lever in the choke position, the flow of fuel into the engine increases and the flow of air decreases.
How long to wait if chainsaw is flooded?
Many people wonder if a flooded chainsaw will fix itself? The answer is yes, but not always. By letting the chainsaw sit for about 20 minutes it will allow some of the fuel inside the engine to evaporate.
Why does my chainsaw not stay running?
Your chainsaw’s engine needs the right supply of air to run properly. A clogged air filter can be the reason why your chainsaw won’t start or stay running. Find your chainsaw’s air filter and remove it. If it’s clogged or too dirty, wash it or replace it.
Can you start a chainsaw with a cordless drill?
NOTE: A battery-powered drill is often not enough to start your chainsaw fast enough. In that case, use an electric drill plugged in a wall outlet. Sometimes the bolt will strip out and when you crank up, the bolt can come out.
How does Stihl easy start?
Compared with conventional starters, the STIHL Easy2Start™ not only requires less effort, but also allows the starter rope to be pulled approximately two-thirds slower. The even pull on the starter rope overcomes the engine’s compression to minimize the strength and effort required to start.
Should a choke be open or closed?
Should Choke Be Open Or Closed When Running? Having been in operation over the last few days, a gas engine that is still warm doesn’t require an choke. When it is warm, the fuel can evaporate quickly. It is recommended you close the choke the most if the engine is cold outside and it is warming outside.
What is the choke on symbol?
The choke on symbol for most small engines looks like a horizontal ( — ) or diagonal ( / ) line. It also can simply say ‘Choke’, ‘Full Choke’, or ‘Start’. The off symbol for most small engine chokes is represented by a vertical line ( | ) or the word ‘Run’. Hopefully you have learned something here.
What is the choke position?
The choke is located before the throttle, and manages the total amount of air going into the engine. The choke is only used when starting a cold engine. When doing a cold start, the choke should be closed to limit the amount of air going in.
How long does a spark plug last in a chainsaw?
A poorly functioning engine in a Stihl chainsaw can mean more work for the operator and can even be dangerous. Consequently, Stihl recommends replacing the spark plug after every 100 service hours.