Precision tool positioning, high accuracy, and high accuracy of the output signal position are all important.
High-quality materials, fine craftsmanship, insulation at the bottom, and greater ease of use are all features of this product.
Suitable for batch processing applications in the woodworking, acrylic, plastic, aluminum, iron, and steel industries as well as other industries.
40mm/1.57Inch is the approximate diameter.
20mm/0.79Inch in height (approximately).
Diameter of the effective surface: 25mm/0.98Inch.
Cable Length: 1.2m/3.9ft (approximately).
Description of the produc.
Specificatio.
40mm/1.57Inch (approximately) is the diameter.
20mm/0.79Inch in height (approximately.
25mm/0.98Inch is the effective surface diameter.
Cable Length: 1.2m/3.9ft (approximately.
Package:1P.
Feature.
When using the tool, it is precise, the accuracy is high, and the position accuracy of the output signal is also high, all of which contribute to its accuracy.
A high-quality material is preferred, the workmanship is excellent, and the bottom is insulated to provide additional peace of mind.
In addition to being smooth and smooth, the crocodile clamp is clamped on the spindle cutter head with a strong amount of clamping force.
Stable and long-lasting, stable and long-lasting, long service lif.
Processing woodworking, acrylic, plastics, aluminum, iron, steel, and other batch processing applications are all possible with this equipment.
Instructions.
Connect the wire from the tool setting block to the tool setting interface on the control card, and the alligator clip from the control wire to the ground wire of the tool setting block, as shown (the alligator clip can be clamped on the main shaft, but ensure that the main shaft and the main board ground wire are connected). While the block is in place, the tool setting process is completed and the block is removed.
1.The red wire is connected to the signal for the control card tool setting.
2.The control card G is connected to the black wire on the control card.
Precautions.
After the tool setting block has been connected, the equipment should be turned on (the part starts the spindle motor). Please do not force the crocodile clamp to be clamped to the spindle. First, use the crocodile clamp to point the tool block surface in the direction of the z axis to see if there is any tool setting action occurring. Clamp the spindle to the table to enable automatic tool setting.
The consistency of the thickness is not consistent.
