One of each grit: 50,100,200,400,800,1500,300.
These are the threads for the females: 5/8″-11. They’re 1″ wide and 1-3/4″ tall.
Vents and can be used with water-fed polishers. Wet use only.
Vertical oscillation is best for even wear.
At its top speed, 4,000RPM.
The Wet Diamond Polishing Drum Wheels are made for wet polishing of sink cutouts or small radiuses. They can be used to do this. It usually comes with grit 50,100. 200. 400. 800. 1500. and 3000, so it’s a full set. From grit 50 to grit 3000, you can polish.
Our recommendation for hard stones is to use a P2 (Position 2) diamond grinding drum wheel with middle-grain grit after the coarse grit P1 (Position 1) diamond grinding drum wheel. This will give you a more even surface to start with before polishing. This will also extend the life of drum wheels that are polished.
It’s possible to buy our adapter for power tools with M14 thread spindles on its own. You can use it with tools that have a 5/8″-11 thread.
Work, but they’re a lot of money and the quality isn’t very good. My surprise comes from the fact that I bought a Damo grinding bit for a 3/16″ radius edge and that was a well made piece. Not so much. There was a lot of glue buildup that I had to get rid of before I could start using them. Find a Dremel with a cutting wheel. After all, they did clean up my countertop’s edges for a sink cutout. I just wish they were a little better made for how much they cost.
