It actually sounds like it is your trigger or switch since it is not doing anything at all. If you do not feel comfortable pulling of the guard and checking with a power meter, then just wait and talk to Dewalt tomorrow.
dewalt band saw stopped working Related Question:
Why is my bandsaw not working?
A bad power supply, broken power cord, failed on/off switch or bad drive motor can prevent the band saw from starting. Check the power supply first. Plug a shop light or other electrical tool into the electrical outlet that you’re using for the band saw to make sure the outlet works.
Why is my bandsaw blade stopping?
Using a dull blade or the incorrect type of blade can cause the band saw to cut through work pieces slowly. The blade will also move slowly through the work piece if the blade is installed incorrectly. A weak drive motor can also cause the band saw to cut slowly. First, check the installation of the band saw blade.
What is a deep cut band saw used for?
The Deep Cut Band Saw has one basic purpose: making clean, straight cuts—and it does this very well. Since I first used the saw to cut steel bar stock, I’ve also cut steel and PVC pipe, steel tubing, conduit, and aluminum bar stock.
Why is my bandsaw blade twisting?
The difference between the steak and the bandsaw is where the steak knife is short and thick, the bandsaw blade is generally long and skinny. This becomes a problem because it is possible to push hard enough on the blade to cause it to twist left or right.
Why does my bandsaw keep jamming?
If there are too few teeth in the cut (teeth are too large), this will also lead to teeth stripping and cracks from the gullets. Not enough teeth also cause jamming and sometimes distortion to the product you are cutting, especially thin walled pipe.
What size blade does a Dewalt DCS371 bandsaw take?
Band Saw Blade Guard, Size 14-1/2 in x 4-7/8 in, For Use With DCS371 20V MAX.
Is a portable band saw worth it?
What to Consider When Choosing Portable Band Saws. The portable band saw is one of the few tools that, when used with the right blade, is equally effective regardless of material. It can cut straight lines or curves, so it can be used for joints, precision cuts, or decorative work.
What causes bandsaw drift?
Drift is cause because the blade buckles under the load. You can see that by stretching a ribbon between 2 points and applying a pressure to one of the edges, it will turn sideway easily. A sharp blade and high blade speed will help a lot with that.
How tight should my bandsaw blade be?
The blade should deflect no more than 1/4 in. A good place to begin is to tension the blade until the meter reads proper tension for the next wider blade. For example, if you’re tensioning a 3/8-in.
Why does my bandsaw cut crooked?
When the band saw cuts crooked, a dull blade, improper feeding, loose blade tension or not using a work piece guide could be the cause. Use the rip fence or miter gauge to guide the work piece uniformly through the cutting blade to make straight cuts.
What speed should you cut metal with on a band saw?
To cut steel, you’ll need to run the machine at a much slower speed — about a hundred feet per minute. A machine running at this speed might look like it’s running too slowly, but running it any faster almost guarantees that you’ll damage the blade.
What is the throat on a band saw?
The throat is the distance from the blade to the vertical frame section of the body of the saw. This distance determines the width of cut that can be completed on the band saw. The throat on a free-standing cabinet band saw typically exceeds the 12 to 14-inch throat of smaller, bench-top models.
Why won’t my bandsaw cut metal?
Band saws are not suitable for cutting very thin sheet metal; a rule of thumb suggests the metal to be cut should be thicker than the depth of 3 band saw blade teeth, however they are excellent for cutting thin walled profiles such as box and angle.
Which of the following should be worn when operating a metal cutting bandsaw?
Wear safety glasses when operating the metal cutting bandsaw. 2. Never wear loose clothing, or jewelry when operating the metal cutting bandsaw.